Transmission Hops when hot

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

The Salmon

TYF Newbie
Joined
Oct 22, 2019
Posts
3
Reaction score
0
My 1999 Yukon runs great after an engine rebuild. I have a long drive to work each day and they are hard miles. Seems as I come to the end of my journey and it is hot, the tranny bangs a little hard between first and second. Is there a tranny thermostat on my 5.7 vortec 4WD? I know I'm due for a fluid and filter change, but I think it is more than that. Any help???
 

Marky Dissod

Full Access Member
Joined
Mar 3, 2023
Posts
1,895
Reaction score
2,598
Location
(718)-

Before you get any of those, might want to consider a used ATF analysis,
might give a better answer than we can.

That said, there are some hard parts that wear out, loosening clearances.
When they do, stuff like that can start to happen.

Do you have an external ATF cooler? Not part of the radiator?
If not, would only help to have one.
 

NickTransmissions

Sin City
Supporting Member
Joined
Mar 9, 2023
Posts
1,088
Reaction score
2,613
Location
The transmission bench
My 1999 Yukon runs great after an engine rebuild. I have a long drive to work each day and they are hard miles. Seems as I come to the end of my journey and it is hot, the tranny bangs a little hard between first and second. Is there a tranny thermostat on my 5.7 vortec 4WD? I know I'm due for a fluid and filter change, but I think it is more than that. Any help???
It's likely that your torque converter clutch regulator/isolator valve(s) and their respective bore in the valve body is worn. Your pump's main pressure regulator valve may also be wearing, requiring higher circuit pressure to stroke those respective valves to complete the gear transition.

The only real way to diagnose is to drop the transmission, take the valve body and stator support to a Sonnax or similar vacuum tester and have both tested for wear.

Any DTCs such as P1870?
 

Eman85

Full Access Member
Joined
Apr 18, 2021
Posts
458
Reaction score
677
Have it scanned for codes, common for the problem Nick mentioned. I have done a fix with the Fitzall kit that changes TCC from pulse width modulated to just on/off TCC. I've also had one that had been fixed with the Sonnax kit but it needed a new torque converter. The Lubegard might buy some time but time will run out.
 
Top