Upper/Lower Control arms ??
- Thread starter 305Tahoe
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
992door
Full Access Member
why are you looking new ones?
Why are you changing them?
No Reason IN Particular.. Im in the Process of the Fabing up a Brake kit for it , SO I will be Replacing Everything up Front at once.
Ball Joints
Tie Rods
Hubs
Shocks
Pitman
Bushings
Endlinks...
Im a bit of a Freak when it comes down to the nitty gritty NEW is Always better//
---------- Post added at 08:08 PM ---------- Previous post was at 08:07 PM ----------
by the way your Truck is HARD!!!
Ball Joints
Tie Rods
Hubs
Shocks
Pitman
Bushings
Endlinks...
Im a bit of a Freak when it comes down to the nitty gritty NEW is Always better//
---------- Post added at 08:08 PM ---------- Previous post was at 08:07 PM ----------
by the way your Truck is HARD!!!
stick with bushings then, no need for a new arm...way cheaper too. Keep in mind poly is great but noisy
why? This is a good bit of money if you didn't know. I want to say upwards of $1000 for both upper and lowers.
So again, why do you need both sets....accident?
They can be found at LMC for replacements, rough country and trail master offer new uppers that help correct the BJ angle after a crank though
So again, why do you need both sets....accident?
They can be found at LMC for replacements, rough country and trail master offer new uppers that help correct the BJ angle after a crank though
