I got the new manifold for my air system today and got to lay the Silverado out for the first time since I repainted the frame and links. Shame I have to put the bed back on eventually.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
cleaned up the electrical connections really good
found the problem Lots and lots of dirt
it was causing a bad connection on the positive cable right on the terminal
Charging voltage went from 14.2 High ripple.(it was all over the place )
to 14.8-14.9 volts stable when charging.
14.4 when charged state.
found the problem Lots and lots of dirt
it was causing a bad connection on the positive cable right on the terminal
Charging voltage went from 14.2 High ripple.(it was all over the place )
to 14.8-14.9 volts stable when charging.
14.4 when charged state.
gooffeyguy
Tom
Get or make a clear bed. Plexiglass maybe?
2001 Yukon SLT
2012 Yukon Denali XL
2011 Yukon Denali RIP 5/20/18
I’m thinking a nice bed, maybe wood slats like the old school ones or just done with bed liner, on struts so it lifts up.
You could probably get a bed made up with a plexiglas floor... would be a b*@ch to keep clean for shows though...
Tonyrodz
Resident Resident
And to keep scratch free.
Hinge the back and have it lift in front like a dump bed?
No clear plexiglass for me, it would look like shit in no time. I would hinge it at the front so you look it from the back or sides.
gooffeyguy
Tom
that hinge would also have to lift it over the roofline before it could tilt forward
No no no.... I’m just thinking of making a cutout in the bed floor, pretty much the whole floor between the tubs, that would lift up. Not the whole bed!
