What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[89Suburban]

 

[89Suburban]

Brake pad check while I’m at it.

 

[89Suburban]

So I set the level to 0 on the rear wheel and here is the front reading. Just a tad over -1*.

 

[89Suburban]

Using the 4 bottles of washer fluid with the string lines on each side squared the lines up to the rear tires then adjusted the front toe in on each front tire to 1/16”.

 

[89Suburban]

Here is the right rear 0’d out and the front measurement. Little too much here. But my driveway isn’t perfectly flat either. I’ll double check those at work on the flat finished warehouse floor to compare later.

 

[PG01]

I did ZERO to my vehicles today. My thighs are killing me today after working on the front suspension yesterday. Must've done

I did ZERO to my vehicles today. My thighs are killing me today after working on the front suspension yesterday. Must've done too much kneeling. Getting old sucks

Lol, what are you 12? Wait till you get to be @Tonyrodz age!!!! Lol… kidding Tony

 

[gooffeyguy]

Lol, what are you 12? Wait till you get to be @Tonyrodz age!!!! Lol… kidding Tony

12, lol. I'm in my 50s

 

[Tonyrodz]

Lol, what are you 12? Wait till you get to be @Tonyrodz age!!!! Lol… kidding Tony

Wish I was 12!

 

[gooffeyguy]

Here is the right rear 0’d out and the front measurement. Little too much here. But my driveway isn’t perfectly flat either. I’ll double check those at work on the flat finished warehouse floor to compare later.



View attachment 377890View attachment 377891View attachment 377892

That all seems easy enough, but very time consuming. I'm just gonna drop mine off at the shop 3 blocks away on Tuesday and pay them the $90 to do it

 

[89Suburban]

That all seems easy enough, but very time consuming. I'm just gonna drop mine off at the shop 3 blocks away on Tuesday and pay them the $90 to do it

It's a challenge, a lot of work and a learning opportunity.