What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[j91z28d1]

Make some toe plates like I did.

I have toe plate with camber gauge as well as turn plates. the problem is my garage floor isn't flat. foundation "settling" they call it around tx haha. plus not being on a lift it's almost impossible to reach any of the adjustments without jacking it up, which throws every off. even then I find string easier to get a visual. I was hoping to avoid all that and just pay someone that. keep that for my projects.


blah

 

[Pandabird]

You should replace those tee's and the heater hose nipple where it is crimped. They are 3 separate parts and a major PITA. But if one of them let's go on the road that is worst, bad news bears.

Sorry but I got a bit hung up on that third part you mentioned. HVAC Tees you mentioned in multiples so I assume it's best to swap both, there's a 113mm and a 111mm version and i'm confused if I should get one of each or two of a kind. Then connectors were seemingly sold in pairs and that's where my math brain said ****. Trying to avoid ordering a full overseas pallet of different combinations, so what's the reasoning behind the different sized tees and does it matter somehow?

 

[89Suburban]

Sorry but I got a bit hung up on that third part you mentioned. HVAC Tees you mentioned in multiples so I assume it's best to swap both, there's a 113mm and a 111mm version and i'm confused if I should get one of each or two of a kind. Then connectors were seemingly sold in pairs and that's where my math brain said ****. Trying to avoid ordering a full overseas pallet of different combinations, so what's the reasoning behind the different sized tees and does it matter somehow?

List of parts in this post:

Coolant Hose Change

Aloha Y’all, Does anyone know how to get the remaining cooling hose part off at the firewall? Appreciate any help or suggestions before I screw it up further. Mahalo for your assistance concerning this matter. Aloha! Bill1013 P.S. Any idea the cost?

www.tahoeyukonforum.com

Picture of how they should be installed. I used a utility knife to cut away some of that firewall matting to make more room to access that tight spot.