where to find a stock drive shaft?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

smoky02

Member
Joined
Aug 18, 2011
Posts
30
Reaction score
0
I have a 97 2 door Tahoe with manual 4x4 lever. I've narrowed the vibration in my drive train down to my rear DS. I've been trying to find a place that I can purchase a new shaft and am not having any luck. Does someone have one lying around or know where I can order one from?

Brandon
 
Last edited:

Ceejkay

Full Access Member
Joined
Apr 8, 2011
Posts
569
Reaction score
24
Location
Ft. Lauderdale, FL
silly question have you taken it to a drive shaft shop and see if its out of balance? if it is they can balance it and will cost a whole lot less than a new shaft.
 
OP
OP
S

smoky02

Member
Joined
Aug 18, 2011
Posts
30
Reaction score
0
That is the problem as I have no way to take it to a drive shaft shop. That's why I was posting this up hoping that someone still had there stock shaft when when they lifted there vehicle.
 

Ceejkay

Full Access Member
Joined
Apr 8, 2011
Posts
569
Reaction score
24
Location
Ft. Lauderdale, FL
you do know you can run with out a front driveshaft. but your best bet would to look in the classified section, check junkyards, and watch craigslist
 
OP
OP
S

smoky02

Member
Joined
Aug 18, 2011
Posts
30
Reaction score
0
Oh my bad, I didn't specify, I need a rear drive shaft. I've already replaced the front. And I would have had it balanced but my shift linkage has been grinding against it for a while
 

Trippers99hoe

Full Access Member
Joined
Jun 5, 2011
Posts
342
Reaction score
90
Location
SW Oklahoma
Oh my bad, I didn't specify, I need a rear drive shaft. I've already replaced the front. And I would have had it balanced but my shift linkage has been grinding against it for a while

If you can't find a donor,A good DS shop can build you a new one.
 

Ceejkay

Full Access Member
Joined
Apr 8, 2011
Posts
569
Reaction score
24
Location
Ft. Lauderdale, FL
ok it did say front at first right? or am i loosing it? in that case, most guys dont have to replace rear when they lift. you could get one out of a 4dr and have a ds shop cut and balance it for ya. sorry i couldnt be more help
 
OP
OP
S

smoky02

Member
Joined
Aug 18, 2011
Posts
30
Reaction score
0
It is driveable, and I could take it to a shop and have them remove and balance it. But the nearest shop is about an hour away and I don't have the time to take off work to do that. I will figure something out, I just thought i would post this here and see if I would get lucky with someone having a spare or knowing where I could get one from.
 

Forum statistics

Threads
132,430
Posts
1,868,025
Members
97,109
Latest member
haloOne
Top