-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.In the morning I’m going to loosen all the control arms and cycle the suspension just to see if that makes a difference.
-
CCarp0331 replied to the thread Lowered suspension still has a lean.I might go try to make my mounts look like that ! It was driver low with the bilsteins so I doubt it’s the belltech. I’m going to...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.I took 1.5” off the sway bar tube. Both coils are brand new 1” maxtrac drop springs. If I cut the tube any more the sway bar will...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.
-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.
-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.I have had an alignment done but I have never unbolted the control arms and revolted. I assumed this was done during that alignment but...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.
-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.
-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.
-
-
CCarp0331 replied to the thread Lowered suspension still has a lean.Never been wrecked but my father did hit a turkey once lol. When it was lifted 3” on the bilsteins and 1” spacer I never measured it but...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.Just replaced both struts with belltechs. Lowered the passenger side an inch and left driver stock and put the 1” drop spring on the...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.Springs are seated right. I trimmed a little off the passenger coil and it dropped it to near even but the driver 5100 is still one...
-
CCarp0331 replied to the thread Lowered suspension still has a lean.I have one but haven’t put it on yet. The lean is really in the front. Back is pretty close. Not sure how I can get another nice drop...
-
CI have an 09 avalanche 4x4. I lowered the bilstein 5100 to the bottom notch and installed 2” max trac drop spindles and 3-4” rear...
-
CI have a 2009 avalanche (dod/non-vvt) with a 6l80 that I will be looking to swap in a 2011 L94 and 6l80 trans. I know the TCM will not...
-
-
Loading…
-
Loading…
