ivin74
Latest activity Postings About
-
-
ivin74 reacted to Geotrash's post in the thread 2017 Escalade/Denali L86 "requires" 93 octane - your experience? with
Like.
I have a different opinion on this. Lots of reports out there on the interwebz of broken pistons and damaged ring lands from running 87... -
ivin74 replied to the thread Your Vehicles as they sit now.....Looks like your structs are shot, time to replace them. Lol
-
ivin74 reacted to 5x10's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Figured out how to get the sun roof shade back in , so before I did, I taped some left over radiant barrier on the sun facing side...
-
ivin74 reacted to nonickatall's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Restored my tailgate lockhook. (Is lockhook the correct word?) Tried to disassemble it, but the rusted screws were to tight in the...
-
I don't want to sound contrary to many of the replies, but I tried the Air Raid which came with the K&N. It's not a hill I want to die...
-
ivin74 reacted to tooleyondeck's post in the thread 07+ Brake upgrade on a 00-06 NBS, is it worth it? with Like.
Why not just go for the 21+ 4 pot upgrade? That seems to be the best bang for buck brake upgrade for the GMT800.
-
Maybe to specially talented others dropping the tank is easier, but not for this white boy.. Iv pulled em from el caminos, my f350, 70's...
-
2001 Yukon Just wanted to say thanks for posting the pics and measurements. I just did the same thing to a 2001 Yukon, and they were...
-
For the doubting haters!
-
Wanted to know what dies in these pumps so i disected it.. Contacts are shot to hell And the plastic bushings fell out of the end...
-
For a 1000 bucks? If the oil analysis and compression check come back alright.... put an oil pump oring in it, rear main seal, exhaust...
-
The factory setup is a damned good design as it isolates the intake air from the engine bay heat. It just looks boring and the duct has...
-
ivin74 reacted to Joseph Garcia's post in the thread Cold Air Intake for the most power?? with Like.
As @Foggy stated above, an MIT tube will clean up the 'plumbing' around the top of the motor and give you a bit of sound. And it comes...
-
Meanwhile, this will be me still on the 2007-2014 forum section in 25 years, driving the same old rigs.
-
if you need a new cam/lifters, oil pan and rear cover gasket, tranny rebuild and converter replaced with a aftermarket one, all the mag...
-
-
Loading…
-
Loading…
