-
-
nonickatall replied to the thread OIL PSI / BRAND / WEIGHT.At first, my truck's oil pressure was relatively low. I started by replacing the O-ring on the oil pump. That helped a little. But... -
nonickatall replied to the thread Low Blinker Fluid?.There are cases where a poor blinker fluid level and winter air not used in winter for the tires, correlate with each other in an...
-
nonickatall replied to the thread Bank 1 and 2 lean codes.A common knowledge is, that problems which apears with cars or woman mostly not disappear from themself... :cool:
-
nonickatall replied to the thread Bank 1 and 2 lean codes.So check first the fuel pressure. There is a connection on the rail for that purpose.
-
Lean on BOTH banks is usually a fuel delivery issue, especially when both banks fuel trims are identical and stay the same (or worse)...
-
nonickatall replied to the thread P0446 after purge valve replaced.If your vent valve fails, the code pops out of the blue, because the system is only checked at certain conditions. When I remember...
-
nonickatall replied to the thread 03 z71 Tahoe didn’t stay aligned.And check the steering wheel adjustment nut. It's located near the master brake cylinder. You should loosen this, grease the rod and...
-
Thanks for the responses. My son did the majority of the work. I helped with some things here and there. Will run some of these...
-
nonickatall replied to the thread 03 z71 Tahoe didn’t stay aligned.He writes nothing about a Shop, i understand that he did it himself... So he has to fire himself? :oops: :Big Laugh:
-
nonickatall replied to the thread 03 z71 Tahoe didn’t stay aligned.I think the problem will be that you haven't tightened the screws on the upper wishbone, where the camber and caster are adjusted well...
-
nonickatall replied to the thread 2001 yukon denali 6.0 oil in cylinder 1 and 3.Yes, you remove the rocker arms, then the valves are closed. Then you give air pressure with an adapter, which you can screw into the...
-
nonickatall replied to the thread Looking for diagnostic scan tool.Wow, only 2500$. What a shot... And Diesel Diagnose is perfect for the Gmt800... I think i buy 2.... :cool:
-
nonickatall replied to the thread 2001 yukon denali 6.0 oil in cylinder 1 and 3.Here you see, as an example a valve, from my Escalade where oil comes down from the valve stem seals... I change the valve stem seals...
-
-
nonickatall replied to the thread 2001 yukon denali 6.0 oil in cylinder 1 and 3.If you have oil in cylinder 1 and 3 you should look with endoscope into the cylinder, to see where the oil comes from. If it's the valve...
-
-
Loading…
-
Loading…
