-
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Here's the results, I did ask about octane and even with the lower compression they recommended staying with premium. I figure the extra...
-
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Still running 91, I figure after the dyno I'll decide whether or not to drop back to regular, which for me is 85 :puke:. Had to bump...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.It's been a bit since the swap, wife REALLY likes the better torque. She didn't think about it while trying to turn left through an...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Still couldn't get ahold of Kevin, but I think I found one of his tunes posted on the hptuners forum that I copied the fuel and spark...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Figured out the evap codes, one of the pins was bent and wasn't seating where it should, was able to bend it back and it looks like...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.They look to be the same size, just figured I would try and use the newer one. Took it out for a test drive this afternoon, can...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.She lives! Got it fired up and had quite a few codes - definitely had to change the throttle body back to the L86 one, still have a few...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.All assembled! Time to fill her up with fluids and install the initial tune! Planning on reinstalling the valve cover covers after...
-
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Just about got this wrapped up. Ended up smashing the purge valve solenoid connector so had to make another stealership run. For vacuum...
-
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.Ran into another little snag. IF you are looking at doing this swap, compare connectors on everything that integrates with your harness...
-
CGreat, now I'm weighing the Cost Vs Benefits of an L8T swap vs pulling and doing a DOD delete on my L83. Thanks to @L8T BURB and...
-
CThe more I am seeing these swaps, the more I want to intentionally find a K2X with a bad motor specifically to do this...
-
Cchevman88 replied to the thread L86 to L8T in '19 Yukon XL Denali.This is true, the bell housing bolt pattern is slightly different from gen4 and prior. Instead of the 6-7 bolts (2 on each side...
-
CHe didn’t bolt up any old GM block. He wouldn’t be needing a “tune” file with a 1970ish BBC bolted up!
-
C@chevman88 He usually lets calls go to voicemail if it's a number he doesn't recognize. Be sure to leave a detailed message and call...
-
-
Loading…
-
Loading…
