Ujoints

steveoe · Jun 9, 2024

I’m wanting to make sure I have the right ujoints. Uj235 are the joints that I ordered but I was thinking this ring in the shaft is for the outside snap rings correct? The ones I took out are inside snap rings. The hoe is a 2008 ltz 4wd. Steel driveshaft. The ujoint at the bottom is the one I’m thinking I need. Thanks for any help

j91z28d1 · Jun 9, 2024

the internal groove you're looking at I believe it's for the nylon that holds the factory u joint caps in. the ones for outside clips should be thinner.

j91z28d1 · Jun 9, 2024

this is the outer clip grove looks like.

steveoe · Jun 9, 2024

j91z28d1 said:
this is the outer clip grove looks like.

View attachment 430025

Thanks! mines more in the middle and the one u showed me is more towards the top. Started second guessing myself. Thanks again

OR VietVet · Jun 9, 2024

The giveaway to the shaft having the nylon injection set up is the little injection holes on the ears. The only replacement set up that will work now is the inside clips, just like what came out of it.

When you go back together, I would always clean the inside of the ears with a fine file to make sure there is a clean/flat surface for the clips to slide in against and to make sure the clips seated properly on the u-joint cups.

Ujoints

steveoe

Member

j91z28d1

Full Access Member

j91z28d1

Full Access Member

steveoe

Member

OR VietVet

Multnomah Falls

Similar threads

Forum statistics

Latest posts