Sparksalot
Supporting Member
They were that quick on my coldcase radiator.
What did you do to your NNBS GMT900 Tahoe/Yukon Today?
- Thread starter phattyford
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,085
- Reaction score
- 2,464
Normally when I order stuff from them it comes out of Vegas.
And this shipped ontrac... Haven't had great luck with them, they usually will say that they delivered something when they didn't, and then it magically shows up a day later so that the driver doesn't get penalized for not delivering something they should have...
guess at least have pressure tested the new bad canister before buying another one. never even though of it haha. 
horrible friction welding the top on. I could probably have just melted it together and not needed to by another. guess that's why I was a close out deal. probably a return or just a blem.
the 2nd new one seems to hold air. so that's a good start haha.
horrible friction welding the top on. I could probably have just melted it together and not needed to by another. guess that's why I was a close out deal. probably a return or just a blem.
the 2nd new one seems to hold air. so that's a good start haha.
RooTBeeRthe1st
Full Access Member
- Joined
- Jul 11, 2018
- Posts
- 1,085
- Reaction score
- 2,464
....well, i got what I paid for i guess, the "quality" of the bbk shortys leaves a lot to be desired.
the welder was unskilled, or not paid enough, not allotted enough time to do a decent job...
also, theres no "ball" connector on the 3 bolt flange...its just flat... and has extra ports(with block off plates) for the older systems I suppose.
I'll grab pics in a bit.
the welder was unskilled, or not paid enough, not allotted enough time to do a decent job...
also, theres no "ball" connector on the 3 bolt flange...its just flat... and has extra ports(with block off plates) for the older systems I suppose.
I'll grab pics in a bit.
blackelky
Full Access Member
- Joined
- Oct 15, 2023
- Posts
- 582
- Reaction score
- 763
Mobil 1 high mileage and wix xp filter. Nice to be able to change my oil again. My HOA in NJ didn't allow that type of stuff.
gooffeyguy
Tom
Quick help. I'm swapping out headlights and I can't remember which connector goes to turn/side marker and which goes to hi/low beam. I have an upper Grey connector and a lower black connector. They are both the same shape and match up to both plugs on the back of the light.
@Doubeleive
@Doubeleive
Well my cyl 8 misfire keeps popping up but only with high rpm and a under a load like going up a hill, then goes away. So either it's a funky plug or I need to have bank2 done. Probably pull it out in the morning and if it looks ok I'll swap it and the coil with #2 just to see if anything changes
Last edited:
gooffeyguy
Tom
Figured it out. I looked up the install video on YouTube and watched closely to see which one they plugged into which.
blackelky
Full Access Member
- Joined
- Oct 15, 2023
- Posts
- 582
- Reaction score
- 763
Have not had mine off in a while so had no idea myself
