Short block purchase

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
flynn78us

flynn78us

TYF Newbie
Joined
Dec 20, 2020
Posts
22
Reaction score
9
I removed all the spark plugs and oil pan drain plug, squirtted in a few ounces of the solvet in each SP hole. Then every 12 hrs or so put a socket on the crankshaft bolt a moved the crank back a forth a little, then replenish ea cylinder with solvent again.

After 48 hrs or so I put towels over each side of the engine and cranked over the engine with the starter 5 or 10 revolutions to remove the solvent from the cylinders.
Put SP and drain plug back in, filled with cheap oil and filter, drove it for 100 miles or so, did a dump and fill with good oil and filter.

This piston/combustion chamber soak, and the new improved valve cover, immediately cured my stuck piston rings and oil consumption problem completely. Today, 5+ yrs and 65k miles later with 196k miles, no oil consumption :)

Here is 1 of the many threads I did back then:
https://www.tahoeyukonforum.com/thr...tor-oil-consumption-tsb-10-60-10-008m.108493/
Did it do anything for a cylinder 8 misfire
 

West 1

Member
Joined
Jan 20, 2023
Posts
62
Reaction score
94
I know this is an old post but I would not touch that engine. Compression is too high to run any type boost on it but the ring gaps are set up to run a blower or turbo? Cam is not a turbo or blower cam. Guy was confused building it that way. Terrible mix for a Suburban with 3.08 gears. The large ring gaps in a daily driver give up ring seal for zero gain. Sorry not just my opinion any engine builder would share the same thoughts.
 

Forum statistics

Threads
132,031
Posts
1,861,259
Members
96,476
Latest member
DoriftuEvo
Top