Search results

  1. PNWYukon

    Service 4wd help

    The 4WD transfer case encoder motor position sensor or the selector switch may fail causing the service 4WD message to be displayed. Fault code(s) stored in the transfer case control module will be of assistance in determining the exact fault causing the message to be displayed.
  2. PNWYukon

    2001 Tahoe - Driver's door lock/unlock button not working

    POWER DOOR LOCKS DESCRIPTION AND OPERATION DOOR LOCK SYSTEM COMPONENTS The power door lock system consists of the following components: The driver door module (DDM) The passenger door module (PDM) The body control module (BCM) The driver information center (DIC) The rear door lock switch The...
  3. PNWYukon

    Truck dead, starter click - Battery is Good

    Looks like it is G105 for you battery.
  4. PNWYukon

    Rear ac not working

  5. PNWYukon

    Truck dead, starter click - Battery is Good

    Are you saying it was perfectly fine before you changed the oil and then suddenly it will not even crank? Turning the key to the on position leads everything to fade out from lack of electricity? Is your vehicle rusted out? If you have corrosion on your battery terminals, then that is your...
  6. PNWYukon

    Rotor and pads recommendations

    I would not mess around with issues like that because you can cause way more damage, lost time, etc. I would immediately either rebuild all four calipers or buy reman AC Delco. Obviously, that shop was shady as hell to do that to you. Anyone that has ever worked on brakes can tell that the...
  7. PNWYukon

    2001 Tahoe - Driver's door lock/unlock button not working

    If it works all times except for the switch, then that is your answer.
  8. PNWYukon

    2001 Tahoe Over heating

    You have a cracked head or a blown head gasket. Worst case, you have a cracked block where the coolant is flowing to the exhaust port. There are other ways for coolant to get through to the exhaust, but these are the most common.
  9. PNWYukon

    2-3 "Flare" When shifting

    A defective solenoid can cause the transmission to slip. What’s a transmission solenoid? A transmission solenoid is an electro-magnetic component used to control the flow of transmission fluid in the transmission. Every time a gear is shifted, the car’s computer – Engine Control Module (ECM)...
  10. PNWYukon

    Rattle

    Wheel bearing would be constant grinding. If it only does it when the transmission is engaged, that could be your answer. A quick help could be to put the rear end on jack stands, get your phone or a camera for a video and place it where you think the noise is coming from and then go through...
  11. PNWYukon

    Rattle

    I had a crazy rattle vibration sound, but it turned out to be the heat shield on top of the muffler. Does your rattle coincide with your RPM's? Check your CV joints. Can you tell if it is a mechanical sound or a loose panel type sound?
  12. PNWYukon

    Service Air Bag light on. Harness underneath seat ripped.

    You can repair it and re-pin the connector. Look Here Should not be too difficult.
  13. PNWYukon

    Suspension advice

    Just need to get a step for your lady. https://www.amp-research.com/amp-research-75115-01a-powerstep-automatic-power-deploying-running-board https://runningboardwarehouse.com/p/amp-research-power-step/ Depending how your rig sits, you might be able to adjust the torsion bar up an inch to get...
  14. PNWYukon

    Battery Not Charging Error Message

    Bulletin No.: 02-06-03-008D Date: July 21, 2008 Subject: Low Voltage Display on IP Gauge, Lights Dim at Stop Lights, Battery Discharged, No Start, Slow Cranking, Dim Lights at Idle, Low Generator Output Models: 1990-2009 GM Passenger Cars and Light Duty Trucks (including Saturn) 2003-2009...
  15. PNWYukon

    Recommendation on gasket

    Thats a place you don't want to go very often, I'd go with OEM and call it good.
  16. PNWYukon

    What do you think of this creampuff?

    It is both. Like anything, it comes down to how bad do you want it before someone else snaps it up. We bought ours with 117,000 and it has been nearly flawless for 80,000 miles. You really can't go wrong a ride this mint and serviced so fully.
  17. PNWYukon

    What do you think of this creampuff?

    That thing is mint and leather! You should offer $10,000.
  18. PNWYukon

    Brake pedal feel low

    With 200K on it you should rebuild the calipers anyway. New pads and new rotors all around. Brakes are too important! If in the rustland get Permatex Caliper grease too and lube all the pad guides and moving surfaces. Check all hard line connections for signs of leaks.
  19. PNWYukon

    Transfer case squeal?

    Transfer case rebuild kit With that many miles, it would be prudent to rebuild the transfer case anyway.
  20. PNWYukon

    Ignition will not rotate after theft

    Ignition Switch Replacement Tools Required J 42759 Ignition Switch Connector Release Tool Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure. Caution: Refer to SIR Caution in Service Precautions. Disable the SIR system...
  21. PNWYukon

    Ignition will not rotate after theft

    The lock cylinder is pretty fragile, try to remove it and see if some pieces are broken. A new one is pretty cheap at RockAuto
  22. PNWYukon

    Abs and brake light issue

    Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition may be an increased air gap between the wheel speed sensor and the hub reluctor ring due to rust and...
  23. PNWYukon

    A/C Question - what is this - AC Delco 4131?

    Looks like this is it
  24. PNWYukon

    Rear driver side window regulator assembly issues

    It's up to you, but you can go Ultra-Power at $20 or AC DELCO at $98 RockAuto has a lot of choices

Forum statistics

Threads
132,237
Posts
1,864,502
Members
96,785
Latest member
Jack23fcb
Top