Search results

  1. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    I have. Not looking forward to it.
  2. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    After extensive tracing, the issue was the turn signal switch. Replaced the entire assembly and everything works again. Thank you all for your assistance in tracking down this issue! Time to replace the door hinge pins now...
  3. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Well...back to square 1. I replaced the 6 wire plug (the 2 green wires were disconnected from the plug), matched all the colors to the original, got everything put back into place, now I have no brake lights at all. Confirmed all fuses are still good after hooking the battery back up. I'm at a...
  4. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Finally got the switch out and discovered 2 wires disconnected from the plug. I'm going to try and splice them together, but if that doesn't work, is there a part number out there for that piece with both plugs on each end? I've found a few with just the connector to the switch, but nothing with...
  5. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Thank you so much for this! I'll get to work on it now and let you know the outcome.
  6. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Please see post I made instead of replying to you directly. Sorry about that.
  7. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Thanks for replying. I have checked all fuses and relays and they all seem fine. I'll get a pic of the switch, but it's right underneath the left side of that bracket I can't remove. I've done extensive video and other searches for this and can't seem to find anything about it. I was all ready...
  8. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Photo of bracket blocking brake switch. I've tried to remove the 2 nuts as well as the 2 bolts on the back sides of the bracket and it doesn't budge. I'm at a loss as to how I need to proceed from here.
  9. Grimace

    1999 Tahoe brake lights staying on - SOLVED

    Hey gang, I have a 99 Tahoe that the brake lights are staying on all the time and I have no hazzards. I figured the hazzards aren't working because the lights are engaged and more than likely, the brake switch needs to be replaced. My question is in viewing the videos out there to replace said...
    • Grimace
    • Thread
    • brake light switch brake lights staying on hazzards not working
    • Replies: 20
    • Forum: Audio & Electronics
  10. Grimace

    AC compressor not engaging

    Checked compression and it was low, but not zero. Added some freon to bring it up a bit and compressor still doesn't kick in. I'm thinking I need to replace it.
  11. Grimace

    AC compressor not engaging

    I have a 1999 Tahoe (dual air) that I was going to recharge the AC, but when I got everything hooked up, the compressor never came on. The clutch does move by hand (a little stiff) and I've checked the relays and fuses associated with the compressor. I'm going to test the clutch tomorrow, but my...
  12. Grimace

    Chevy P30 question

    Thanks Kenny. I may end up pulling the steering wheel anyway to replace it...it's kind of rough.
  13. Grimace

    Chevy P30 question

    OK...I know this isn't Yukon or Tahoe related, but I thought I would ask you guys first. I just purchased a 1976 Chevy P30 stepside van and the hazzards and blinkers are not working. I figured it has to be a relay switch, but I haven't had time to look for it yet. Does anyone know where this...
  14. Grimace

    Transmission shifting weird issue....

    OK quick question for the group. I just did a standard tune up (plugs, wires, filters, etc) and when I went to test, my check engine light popped on. My 1999 Tahoe is hesitating when I step on it and took it down for a code check. I got an O2 sensor, bank 2, sensor 2 code, a left front speed...
  15. Grimace

    shifter handle loose

    Column Shifter mechanism Well I got it changed out today, I couldn't figure how to get the top plastics off, so it took a little longer than I wanted to get the ignition clip in. The old piece was snapped right in half...looks like it's been broken for some time now with the shiny spots on the...
  16. Grimace

    shifter handle loose

    Thanks for the quick response. I'm just waiting for the part to arrive and then I will dive in. Any idea how long this should take for someone who is above average do-it-yourselfer?
  17. Grimace

    shifter handle loose

    1999 Tahoe shifter I have a question, I have a shifter that now will not go into drive and is very sloppy. I know I have to replace the shifting mechanism on the column, my question is do I have to drop the steering column or can I just remove the plastics and get to it from there. I haven't...

Forum statistics

Threads
132,714
Posts
1,873,072
Members
97,537
Latest member
CHENTE

Latest posts

Top