Confirmed all 4 O2 sensors move between .1 and .9 volts. They are all moving up and down when driving. Cat Converter got as hot as 3150 F while driving. I did observe fluid coming out of exhaust but not at the end of the tail pipe like you normally see. Its leaking like right before the...
When mine popped, I tried to use zip ties but they would only work for temporary usage. I could feel the shifter fighting to get into gear. I ended up getting the part for o'reilly but definitely didnt spend $20, it was max $15. Mine broke when I was picking something up from a person's...
I havent checked in for a little while but my Hummer mounts are still working like a charm, no issues. Hopefully everyone is moving towards these and not another tahoe mount.
Hi, I have a similar code and was looking at the scan tool. You mentioned the following:
"Scan tool shows the rear O2s have nearly even voltage in closed loop and don't follow the fronts"
While sitting at idle, mine shows voltage matching for 02B1S1 and O2B1S2. Whatever S1 volt changes to...
Going with Felpro gasket and permatex black gasket maker combo. Confirmed 10 bolt diff. Using 3 qts of valvoline 75w 90 for rear diff, 2 quarts for front diff, 2 quarts of tranny fluid for transfer case. Blue loctite for rear diff bolts and white loctite for fill and drain plugs. Saving this...
when I turn right turn signal, my high beam comes on. I resolve by holding the switch towards me. Sometimes twisting the stalk a little gets it to go away. The high beam stays on even after turn signal goes away. Instead of replacing stalk and go through this again, thinking of doing this below:
Some good news. I banged on the metal side of the motor like a starter and it started to work again but you could tell its on its way out. I was able to close sunroof and disconnected connection until I get a new motor to replace. The fact that it made improvement with that small action...
I was able to get to the motor out and I also confirmed the clicking sound was coming from motor. This must mean its getting response from the switch. So not sure what would cause it to not move. I dont think its an issue with things in the way of the rails because it would atleast make noise...
I havent used sunroof in a while because of the weather but yesterday was a good day. I open sunroof and didnt attempt to close it until hours later and it wont close. There is no noise except a click sound which i believe is the norm when you try to one click full open/full close sunroof. I...
This site has blessed me with the knowledge to change all the fluids in my truck when i first got it. I wanted to see if the recommended fluids changed along with how much. I tried searching but I only seem to find discussions of issues/replacements rather than maintenance so far. I believe I...
Finally took time to look into this and that is EXACTLY what happened. Had to remove sun visor and a pillar which gave enough access to see the failure. Added a rubber hose to secure connection and now all is well. THANK YOU!
I had same issue. Drain hose that connects to sunroof was disconnected. It can shrink over time and pop off. You can add some type of rubber hose fitment to reconnect
Yes I do. I was thinking the rubber for window seal that seperates body from door was an issue or even the SAT antenna from what I saw on youtube. Any suggestions?
When it rains, I find a little puddle on the driver floor mat. I can also catch drips coming from the a pillar if it rains bad enough while I'm in car. I think its related to some window rubber. Just wondering what to buy and how to install? This is only on driver side.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.