Still going on
https://www.carcomplaints.com/news/2024/toyota-tundra-engine-recall-lawsuit-class-action.shtml?&ad=dirN&prod=Secure&cmpgn=29308&annot=false&sameTabLaunch=false&installSource=other&ctype=web&browser=Secure&darkMode=false&ueid=f1235acb-1e69-46b8-8e07-32aa574a2503&doi=2023-12-10
Is there a part number on the oil conditioner they used??
This page is out of 2024 Yukon owners manual the bottom three line says not to use addives or flushes.
318 Vehicle CareWhen to Add Engine OilIf the oil is below the cross-hatched area at thetip of the dipstick and the engine has been...
If engine goes south and oil level on dip stick is in the hatch marks there is no way they can refuse warranty for amount of oil in engine and OP states that what he does with his vehicle.
They didn't install glass correctly from picture of mine.
https://g.oempartsonline.com/oem-parts/gm-passenger-side-windshield-molding-15291274?c=Zz1ib2R5JnM9Z2xhc3Mtd2luZHNoaWVsZCZsPTUmbj1Bc3NlbWJsaWVzIFBhZ2UmYT1jaGV2cm9sZXQmbz10YWhvZSZ5PTIwMDQmdD1sdCZlPTUtM2wtdjgtZmxleA%3D%3D
If you can decide which side tick is I would pull valve cover and see if you can see rocker arm that isn't moving correctly and some owners have found bent push rod which is easily replaced.
If bent push rod I would look at replacing valve solenoid manifold.
I wouldn't drive or run much to keep...
If you like vehicle and plan on keeping get with a trusted GM dealer to have repaired correctly and with GM parts if you are disappointed and don't like vehicle I would have Carmax take vehicle back and start over with another vehicle.
After looking at the lifter I would replace cam but doing that all lifters should be replaced then after that you have to wonder about doing a complete VVT delete.
I have used these plastic razor blades in link on the double face tape before and with goo gone worked fine. Then used eraser wheel on drill to clean everything up worked fine.
Buy the good plastic blades I have bought some on amazon and they didn't perform the best...
Drill a 10-32 tap drill into side of post until you see brass shavings coming out then tap and install 10-32 set screw in it to stop sleeve insert from turning hope fully someone didn't lock tight screw.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.