Search results

  1. denalianyone

    Transmission fluid leak from INSIDE 16 pin transmission connector

    Yeah the clips from the TECHM that hold the sleeve clicked in without a problem. I agree with u that it has to be pushed in a little further. Once I drop the pan again I’ll bang it with a mallet to crush the washers more flush.
  2. denalianyone

    Transmission fluid leak from INSIDE 16 pin transmission connector

    I replaced this sleeve twice already but fluid is still apparent INSIDE the connector as your original post stated. There isn’t fluid leaking from the exterior of the passage sleeve where the two washers are. Is fluid supposed to be inside and help with conductivity? I’m so confused.
  3. denalianyone

    Figured out what was causing HIGH long term fuel trims...

    Do you have a pic of this o-ring you mentioned?
  4. denalianyone

    07 Tahoe does A/C compressor cycle on and off?

    I confirmed today in my 08 Escalade that the compressor does work like explained here. In fact the air blows stronger and colder when the recirculation button is pressed and the compressor cycles on n off. When the button is turned off with the compressor constantly on, the air is cold but not...
  5. denalianyone

    08 Tahoe Rear AC not blowing cold

    Did you fix your issue? There are two orifice tubes in the rear that need to be checked if air is struggling to get cold. Now if the high side line is cold underneath and not cold air in the rear, then the blend door is the culprit.
  6. denalianyone

    6L80 Sonnax ZIP Kit, Pressure Switch rebuild, remote filter install, and fluid flush in 2013 Escalade ESV (Pic heavy)

    I replaced this sleeve twice and it’s still leaking from the connector. I have a new TECHM installed as well. At this point I’m tired of dropping the pan to address the sleeve. Plus the pins aren’t loose.
  7. denalianyone

    Another water leak on driver's side

    Spotlight hole?
  8. denalianyone

    Full "neon" escalade third brake light

    They used to sell them on eBay but now it’s just the led bar as opposed to the individual leds that match up perfect with the OEM esky lights. Another option is to find someone local or on social media willing to tackle the job of extending the length of your OEM brake light.
  9. denalianyone

    P0442 (Small Evap Leak) Mystery

    I tuned mines out through my Autocal because in NYC we don’t have to worry about emissions.
  10. denalianyone

    P0442 (Small Evap Leak) Mystery

    I Is there a way of disabling the evap purge/seal test with a tune? Similar to tuning out an o2 sensor.
  11. denalianyone

    Hard initial shift ..traction control light on

    The VCX Nano comes with the knockoff Tech2 with no subscription and works flawlessly.
  12. denalianyone

    Erratic intermittent no crank no start

    I had the exact same codes and symptoms plus the truck in limp mode not going over 30mph two days ago. I went to YouTube and found a video upgrading the ground strap and walla no more issues. I used 0/1 gauge as opposed to the smaller wire as stated in the video. You may want to change the...
  13. denalianyone

    Hard initial shift ..traction control light on

    I read the codes yesterday and today the BlueDriver has power but it won’t pull the codes. It’s as if the obd2 isn’t responding. This lead me to believe it’s an electrical issue apparent somewhere.
  14. denalianyone

    Hard initial shift ..traction control light on

    I’m experiencing the same symptoms. Did you fix it?
  15. denalianyone

    Full "neon" escalade third brake light

    Ok thank you…
  16. denalianyone

    Full "neon" escalade third brake light

    I had a custom full led bar a few years ago but one of the leds went out and I put the oem one back on. I was trying to make sure this Amerilite bar was the same as the one in the pic I included.
  17. denalianyone

    Full "neon" escalade third brake light

    Is the full led 3rd brake light individual LEDS in comparison to the OEM Escalade lights?
  18. denalianyone

    No crank no click no start after driving just fine. Potentially related to fuse 35 / DLIS in 2011 Yukon

    Check ground wires..I don’t think the issue was related to that fuse. The truck sitting for a little while triggered something that may have been corroded or loose. The DLIS is the ignition switch and theft deterrent module.
  19. denalianyone

    stiffer shocks

    I agree . They are way too bouncy and wish there was an alternative for those who kept autoride.
  20. denalianyone

    Sway bar end-links

    What are the name of these?
  21. denalianyone

    Strange wet spot in carpet

    Where is this located?
  22. denalianyone

    Rear suspension squealing sound!!

    Yeah I may need to find an assistant to isolate the noise.
  23. denalianyone

    Rear suspension squealing sound!!

    I have an 08 Esky with about 116k. Recently I have experienced some swaying with going around uneven corners in the rear of the vehicle. There is a squealing sound which is very annoying. Up and down movement doesn’t generate it, only side to side if that makes sense.
  24. denalianyone

    Adjustable rear control arms.

    Shit..glad I seen this pic b4 pulling the plug on those pricey rear arms. I just wanted to purchase them to move my rear wheels back after dropping the suspension in the rear. Sent from my iPhone using Tapatalk
  25. denalianyone

    Trying to find the source of a coolant leak..

    Yup so the leak was at the top of the tank with a hairline hole. New radiator was installed n used about 2 1/2 bottles of dexcool to refill. Sent from my iPhone using Tapatalk

Forum statistics

Threads
132,730
Posts
1,873,288
Members
97,558
Latest member
BurbyRST

Latest posts

Top