i thought about putting the rubber spring seats back in the rear. i know it wont get me up an inch. what are my option with raising the rear up, new springs. the issue i have is i purchased a 3/5 kit and got a 2/5 kit. just frustrating.
I have my old stock keys from my silverado. im...
I will get the measurements tomorrow. I think they were 32.25 in back and 33.5 in front. The rear sits lower. My tire ad wheel combo are 285/50/20. I don't think I have leveling keys. The truck had a rake when stock. A buddy of mine used leveling keys in his tahoe and my front sat lower when...
i just did a 3/5 with tb 4320 springs 3" control arms. my rear sits a touch lower. i do have the spring seats out. can i get lowering keys and still get close with alignment. i want about an 1.5" lower in front. what are my options.
I just dropped my tahoe 3/5 with djm control arms. The front looks like it sits a little higher. I don't know where my instructions are and I remebmer something about cutting the front bumpstops down. Is this correct. Or should I unload he torsion bar screws. If I need to cut the bumpstops how...
no i just finished it tonight. it goes to the alignment shop tomorrow. just wan to make sure that this is normal and can be fixed by an alignment shop.
i just dropped my tahoe 3/5 and my steering drifts from left to right. i noticed that my tires are toed out. is this common on a drop. just want to make sure i didnt also mess anything else up.
I just want to be clear when i wrote diff i mean the whole assembly case and all. i just want to pull mine out an put a new one in and be done. i just got done changing my fluid and there was alot of metal on the magnetic bolt. so i will need to replace the unit.
as title states are the nnbs and nbs front diffs interchangeable. I think i have bad carrier bearings in my front diff. i have found a nnbs front diff for $500 with 24 miles on it. i would like to swap it out instead of having a shop rebuild mine.
I have a problem with my hvac. i hear a squeaking noise coming from under the dash. it sounds like an o-ring is spinning and is squeaking against some plastic. I have the dual temp manual slider controls. i also have rear heat controls that work.
I have noticed that if i have heat blow on...
thanks for the replies.
with spindles i have heard a lot of alignment issues that need to be correct by buying camber kit, the decreased turning radius.
the DJM control arms also have their fair share of issues. Like the ball joints included are cheap and should be replaced right away...
looking to do a 3/5 drop. i have been reading about rear coils but have not found my answer.
Looking to get a Mcgaughys 3/5 kit. how are the rear coils with that kit. i have read that the djm coils are horrible and bell tech are great. what about the mcgaughys coils how do they ride...
thanks for the reply
its not the engine. it has something to do with the drivetrain.
noise happens more when at higher speed. i have changed the gear oil n the front diff. looked new. it did not seem low. im thinking a bearing in the diff.
Well I need help, and what a better place to come to first. I'm sure we can figure the problem out.
I have a 2004 tahoe ls 4wd with 80k. bought it a month ago.
I have a intermittent noise. Sounds like a machine gun being shot on burst in no particular rhythm or length. I cannot create the...
i have a 2004 tahoe with a brake issue. when i depress my pedal it does not apply the brakes until half way down. could it be a master cylinder or booster or both.
thanks
i am going to pick up a nbs tahoe. i have two to choose from both 2004. one is a loaded lt and the other ls. the lt has the awd. the ls 4x4 with the option to leave it in 2wd. does the awd hurt gas milage compared to the leaving it in 2wd. is the awd option like the auto 4x4 in that it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.