'02 Loose Shifter

[DrummerDude70]

Ok, so I had my gear shifter in my '02 Z71 come loose a couple of months ago, real loose. Have NEVER had that happen. I opened everything up to find that the bolt that holds it in place had backed off a good bit. I put some blue Loctite on it, tightened it up real good and didn't think much else of it. Now, after about a month, the thing had backed off again, so same thing with the Loctite, just more of it this time and let it sit for a couple of hours before reassembling everything to allow it to set up. Now, it has backed off for the 3rd time. Anyone else have this issue? Were you able to resolve it?

 

[noodlesandsam2]

any pics possible? did you just get this truck? I've never had this issue - make sure that is the right bolt - do the threads match the other part?

 

[DrummerDude70]

I've owned the truck for 18 years. It is the original factory bolt, I just removed, added Loctite and reinstalled. As far as pics go, there's not much to see. It's an allen head bolt.

 

[Doubeleive]

I've owned the truck for 18 years. It is the original factory bolt, I just removed, added Loctite and reinstalled. As far as pics go, there's not much to see. It's an allen head bolt.

use red loctite then

 

[DrummerDude70]

I had considered using the red, but if I ever needed to replace the gear shifter, I might be up the Proverbial creek!

 

[Fless]

Use orange, then.

 

[Rocket Man]

I had considered using the red, but if I ever needed to replace the gear shifter, I might be up the Proverbial creek!

You can use heat to loosen the red stuff if you need to remove it later.