Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
So I pulled off the wheel and caliper today and checked my pads there fine, and the slider bolts are lubed fine. BUT I ran in to bigger problem, I had to push the caliper pistons back in to get the caliper back on the rotor, after I done this I pumped my brakes up and I can’t get any pedal pressure and have no brakes. I did not mess with the bleeder screw or line to get any air in lines, just pushed the caliper pistons back in. I tried bleeding the brakes afterward, but the brakes will not bleed. There’s no fluid coming out or anything, even tried bleeding it at the master cylinder and no fluid even coming out there. Then I tried the passenger side wheel, nothing same problem. Any suggestions, I’m at standstill with it.
I removed the line on the master cylinder closest to the firewall first no fluid came out, so then I removed the other line and fluid came out of it.
