2008 tahoe p0306 issue

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Nickct203

Member
Joined
Feb 2, 2018
Posts
86
Reaction score
49
I have a 2008 tahoe ltz 5.3. My wife was driving yesterday and all good until she came to a red light. The service stabilitrak, Trac control off and the check engine light all came on. Well the CEL was flashing then went steady. She said it had a real rough idle and could barley drive. I got home from work put my scanner on it and got a P0306, cylinder 6 misfire. I changed the plugs and wires cause it needed it regardless, and still no good. Swapped the coil packs with cylinder 6 and cylinder 1, still no good. You can hear that freaking cylinder 6 rapping away. Does anyone have any idea what else? I did notice that when I went to the pass side to change the plugs and wires I smelt an over abundance of gas. Could it be that the injector went bad? I also notoce that after doing the work all the lights, specially the inside lights were pulsating. My wife said its been doing that but not as bad as it was now. Could a bad alternator or the voltage regulator in the alternator be bad and cause all my issues?
 

Geotrash

Dave
Supporting Member
Joined
Feb 16, 2018
Posts
6,427
Reaction score
15,930
Location
Richmond, VA
How many miles? The stabilitrak and traction control system will shut off and trigger the warning if the engine isn't running right and is throwing codes. But when you say you can hear cylinder 6 rapping away, can you elaborate a bit more please? Is it a loud knocking or tapping noise? If so, you likely have a failed AFM lifter. #6 is an AFM cylinder.

Pulsating lights could be caused by the uneven idle that's accompanying the problem, or it could be a separate issue, such as a failing alternator as you suggest. But that would not be the cause of the misfire.
 

02Z71Raven

Full Access Member
Joined
Jun 1, 2021
Posts
117
Reaction score
115
Injectors aren't too difficult to swap either. Check to make sure the connectors are clean and no signs of corrosion.

I did all these things and then sent it to the shop and found a collapsed lifter had worn into the cam. I hope you have better luck.
 

swathdiver

Full Access Member
Joined
May 18, 2017
Posts
19,582
Reaction score
26,270
Location
Treasure Coast, Florida
I have a 2008 tahoe ltz 5.3. My wife was driving yesterday and all good until she came to a red light. The service stabilitrak, Trac control off and the check engine light all came on. Well the CEL was flashing then went steady. She said it had a real rough idle and could barley drive. I got home from work put my scanner on it and got a P0306, cylinder 6 misfire. I changed the plugs and wires cause it needed it regardless, and still no good. Swapped the coil packs with cylinder 6 and cylinder 1, still no good. You can hear that freaking cylinder 6 rapping away. Does anyone have any idea what else? I did notice that when I went to the pass side to change the plugs and wires I smelt an over abundance of gas. Could it be that the injector went bad? I also notoce that after doing the work all the lights, specially the inside lights were pulsating. My wife said its been doing that but not as bad as it was now. Could a bad alternator or the voltage regulator in the alternator be bad and cause all my issues?
Pull the rocker cover and see if it's a busted spring, rocker, collapsed lifter, bent pushrod, etc.
 

iamdub

Full Access Member
Joined
Apr 23, 2016
Posts
20,821
Reaction score
44,943
Location
Li'l Weezyana
I have a 2008 tahoe ltz 5.3. My wife was driving yesterday and all good until she came to a red light. The service stabilitrak, Trac control off and the check engine light all came on. Well the CEL was flashing then went steady. She said it had a real rough idle and could barley drive. I got home from work put my scanner on it and got a P0306, cylinder 6 misfire. I changed the plugs and wires cause it needed it regardless, and still no good. Swapped the coil packs with cylinder 6 and cylinder 1, still no good. You can hear that freaking cylinder 6 rapping away. Does anyone have any idea what else? I did notice that when I went to the pass side to change the plugs and wires I smelt an over abundance of gas. Could it be that the injector went bad? I also notoce that after doing the work all the lights, specially the inside lights were pulsating. My wife said its been doing that but not as bad as it was now. Could a bad alternator or the voltage regulator in the alternator be bad and cause all my issues?

As @swathdiver said- Check under that passenger side rocker cover.
 

Forum statistics

Threads
132,319
Posts
1,865,896
Members
96,911
Latest member
1stYukonXL
Top