2015 Durmax swap and solid front axle build under way.

[Racing4funn]

Yea any advice would be nice.. just kinda winging it as I go.

Motor, trans, transfer-case mounted.. Working on wiring. I got a full service manual on the Yukon and the 2013 Silverado the drivetrain come out of. All circuits seem to be there for the wiring to be complete.


Might be wondering why.. well the transmission went out and the motor has the annoying high pressure tick.. So F this drivetrain!

 

[Racing4funn]

doner

 

[Racing4funn]

test fit

 

[Racing4funn]

motor wont drop low enough. Maybe a pan swap but I want a solid axle anyways since Im retaining the 4x4. But note that the motor is , maybe low enough but the steering electric rack is missing.. Motor will not go low enough with the attached.

 

[Racing4funn]

IFS brackets gotta go.. IFS front sucks anyways!

 

[Racing4funn]

cleaned that nasty crap tar GM puts on the frame... They are so cheap. Also put 3 coats of Lizard Skid sound deading and a few thermal coats. Continued the coats all the way to the rear axle

 

[Racing4funn]

painted frame and insulation blanket back on

 

[Racing4funn]

motor cleaned up and in.

 

[Racing4funn]

working out wiring and cluster is alive.

 

[Mechanic421]

Bad ass good luck!