2016 Tahoe 4” Fabtech “budget”

[BrownSunshine]

Got the lift done on my wife’s car finally. Went with the 4” Fabtech Budget kit and 305/55r20 Ridge Grapplers on 20x9 0 offset Fuel wheels


Sent from my iPhone using Tapatalk

 

[olyelr]

Heck yea looks great!

 

[JohnnyG]

Just wondering how your car is doing after a couple years?? I'm looking for a 4" lift for a 2017 Yukon. debating between a couple...Fabtech, BDS, or maybe Cognito....

 

[BrownSunshine]

Just wondering how your car is doing after a couple years?? I'm looking for a 4" lift for a 2017 Yukon. debating between a couple...Fabtech, BDS, or maybe Cognito....

Well we’ve only had the car for about 2 months. But so far the ride is almost as good as stock. I say almost because it does ride rougher, but more of a comfortable rough, if that makes sense. Nothing is jarring but you can tell it’s not as smooth as stock.

As far as drive line angles go, They are actually very good. I was impressed when I got under the car and looked at them.


Sent from my iPhone using Tapatalk

 

[Tadow39]

Well we’ve only had the car for about 2 months. But so far the ride is almost as good as stock. I say almost because it does ride rougher, but more of a comfortable rough, if that makes sense. Nothing is jarring but you can tell it’s not as smooth as stock.

As far as drive line angles go, They are actually very good. I was impressed when I got under the car and looked at them.


Sent from my iPhone using Tapatalk

it looks great! I also have the Fabtech 4” budget lift on my 16 Yukon XL. My Yukon still has the forward rake. What did you do to get yours level?

 

[BrownSunshine]

it looks great! I also have the Fabtech 4” budget lift on my 16 Yukon XL. My Yukon still has the forward rake. What did you do to get yours level?

So it’s not perfectly level, it’s actually got about a 3/4-1” rake to it. However, I did add a small SMALL spacer to the front, I think it’s around 1/4” thick.


Sent from my iPhone using Tapatalk

 

[Bignate87]

I have a 2016 Tahoe LT 2 wheel drive with 3.5in lift in the front and 2in in the rear. Looking to see what offset I'm going to need if I run 33x12.50 on the stock 18s? Any help or advice would be awesome. Thank yall in advance