26x10 or 26x10.5 on lowered suburban. What offset/et

[jordan11]

I have 24” reps right now but looking at 3 piece 26” wheels. Anyone with x10 or x10.5 wheels? What et are you running? I don’t want wheels sticking out past body.

 

[89Suburban]

@Doug118

 

[Doug118]

On stock suspension, any x10 should be fine. 10.5 might be okay in the back with a smaller tire. If you’re lowered more than like 3/4, you’ll most likely get into rubbing issues up front

This is a 26x10 +31 with a 305/30/26

 

[Doug118]

This is with a 295/30/26. Front fenders are pulled. Rears have the fender lip cut off. Not sure how much you’re lowered but this is pretty much the extreme as far as static with big wheels goes. Wheels hit the firewall pretty hard and made it a nightmare to make even somewhat tight turns

 

[Doug118]

In my opinion, if you’re ordering something custom, I’d go like 35mm up front and like 30mm in the rear. That also depends on how small of a tire you can run

This is a x10 13mm offset with a 275/25/28 just for reference. The fronts would stick out way past the stock fender

 

[jordan11]

Those are all a bit too close to the fender for me. Also wondering if last gen and this gen fit the same.

 

[jordan11]

The wheel company emailed me some specs, 26x10.5 et 26, not sure if that’s good or not. I really don’t want any rubbing anywhere. This is what I was looking at.

 

[KMeloney]

Those are all a bit too close to the fender for me. Also wondering if last gen and this gen fit the same.

You're looking at two gens ago... And no, they don't fit the same.

Doug should be commended for trying to help, but the backspacing between the last two gens and this gen is different.