Just got the Readylift sst 4/3 kit(69-3495) for my 08 Yukon XL and been struggling with what tire size to buy for the new wheels I bought. I want the largest tire I can put on without an excessive amount of trimming. The wheels i have are Ultra 249 Predator 2 17x9 +1mm offset. I've been going crazy trying to decide what tire to mount on the wheels. The lift isn't on yet but am planning to install it next weekend and want to have everything ready to go before hand. Readylift says 33x12.5 no rubbing, I'm thinking 305/70. Going through the site it seems like I'm one of the few not going with 20s so its hard to get a good look at what others have already done and know what does and doesn't work. Any advice?
4/3 lift wheel and tire?
- Thread starter cjf
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
01Konvict
Boats n Hoes
Don't think they will fit without some rubbing. You might get some rub at the bottom of the front fender liner. Little trim and good to go.
Ended up putting on 295/70r17 Nitto Terra Grappler G2 tires on it. Had to trim a bit more than I liked but got the look I wanted. Will post some pictures of what I trimmed off as soon as I can, I haven't taken any pictures of what I trimmed yet. But here is one of it with the lift and tires on it. Hopefully it shows up. I'm new to the forum thing.
Last edited:
01Konvict
Boats n Hoes
Looking good dude, glad it was some minor rub
