Ccm 2.5"f......1"r?

[TREYR8D]

So I finally purchased the leveling kit for the wife's '07 Z71 Tahoe. Got to installing last weekend and only had enough time to do the front. When I was finished i measured the front and back, ground to wheel wells, only to find that they were exactly even front to back. I double checked from top of tire to wheel well and they were all the same. So for right now I'm going to leave the rear "leveling kit" off of it. I don't plan on hauling anything anytime soon, so i'm not too worried about loading the rear down, giving it the Cali lean. I wanted it to be perfectly level and it is.

Anyone else experienced this same phenomenon?

 

[Zed 71]

When I installed the exact same kit (front and back) on my 07 Z71, the rear was ~0.25" higher than the front. So I am guessing that without the rear spacer, the rear would have been ~0.75" lower.

 

[wvz71]

Treyr8d,

Do you still have this same set up? Do you have any pictures? I would like to do the same set up with the 2.5" in the front and nothing in the back.

Thanks.

 

[Hawkeye]

Have CCM questions??

I have an '08 Z71 2WD and I'm considering the CCM 2.5f/ 1.5r leveling kit. I'm curious as to how this kit affect this ride and steering of the vehicle compared to stock setup. The final setup will be this kit with 305/55/20 TerraG or Cooper Zeon LTZ on stock 20" LTZ wheels. Can anyone give me some insight to the ride and steering after the kit was installed?

 

[Wakinvol]

On my 08 LTZ I didn't notice any ride difference whatsoever. The only difference was that the view out the windshield higher! Steering was fine but I had slight rub on the front fender liner (275-60/20 Nitto Terra Grapplers) but nothing that couldn't be fixed. I didn't like the look so I took it off, but it wasn't as a result of the kit itself. I think it would be great on a Z-71

 

[felixgun]

On my 08 LTZ I didn't notice any ride difference whatsoever. The only difference was that the view out the windshield higher! Steering was fine but I had slight rub on the front fender liner (275-60/20 Nitto Terra Grapplers) but nothing that couldn't be fixed. I didn't like the look so I took it off, but it wasn't as a result of the kit itself. I think it would be great on a Z-71

Does the same CCM 2.5/1.5 kit fit on 4x4 and 2x4 GMT900 vehicles? Also how much did you pay for it?

 

[InTruckDesign]

Felix, the CCM kit will fit on both the 4x4 and 4x2 tahoes. Though I do not remember them offering a 2.5F/1.5R, I believe the rear spacer is only 1". Your best bet for pricing is to contact them direct via their website www.ccmoffroad.comor check out ebay(I know they have a store on there)

 

[Wakinvol]

Exactly.. The CCM is a 2.5" front 1" rear. With shipping and all it was $141 from Cali to Tennessee. Kit is $129.