Does anyone have a center console on 2nd roll buckets

[ivin74]

Several months I bought a front center console from a 02 Yukon just like the first picture. Finally was able to start the fabrication to get it installed in between the rear buckets seats of my Yukon. Attach is the first picture of the progress.

 

[ivin74]

Once you have the rear legs in place and the front piece screwed in take measurements and build a cardboard template for the sides like the pic below. This will be a trial and error so please be patient until you get it right. Once you get it right make it out of wood and attach it to the center console

 

[ivin74]

Once the templates are done attach them to the sides like the pic attached.

 

[ivin74]

As you can see the pictures, I filled in the gap left from the plastic lip to the wood with bondo and start sanding it. I'm hoping to have it painted this weekend

 

[MrBalll]

It's looking good. Ready to see it painted and mounted.

 

[YukonXL04]

Hey, just a thought. You might look at getting some matching carpet and wrap just the bottom so you don't have to try to match the texture

 

[ivin74]

Here are the finished pictures unmounted, I could not find the correct SEM paint color so I bought the closes color available, I'm not to concern with the color as i'm going to get the console leather wrapped when I replace the carpet after the holidays.

 

[ivin74]

Attach are the pictures with the console installed. You can't really see the color difference on the sides once its installed.

 

[ivin74]

Hey, just a thought. You might look at getting some matching carpet and wrap just the bottom so you don't have to try to match the texture

Carpet was on my mind but my kids are freaking messy (just look at how dirty they got my carpet) so I'm going to leather wrap it after the holidays.

 

[Tonyrodz]

Did you hook up the controls and the power point?