Door issues

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

dfdtruckie

TYF Newbie
Joined
Nov 26, 2009
Posts
5
Reaction score
0
Location
denver
95' Tahoe makes a loud rubbing sound from the driver's side door. There are no obvious dents and now I have to pull/close the door fairly hard to get it to stop the door ajar alarm. Is it something with the hinges? Thanks for the help
 

qlc1964

qlc1964
Joined
May 2, 2009
Posts
168
Reaction score
2
yes you have worn hinges &the pin also check the door stricker

thats the big bolt.
 
OP
OP
D

dfdtruckie

TYF Newbie
Joined
Nov 26, 2009
Posts
5
Reaction score
0
Location
denver
So do I just replace that bolt? Are there bushings that I could install to avoid this later? Thanks for the help
 

95TwinTT

Full Access Member
Joined
May 23, 2009
Posts
357
Reaction score
0
Location
Minnesota
Most often the problem can be cured by replacing the bronze bushings. I used an engine hoist to hold the weight of the door, while I changed mine.:)
 

rucr8z2

Full Access Member
Joined
Nov 11, 2009
Posts
100
Reaction score
3
Location
Saluda,Va.
NAPA makes a repair kit for the hinges- 1 kit per hinge---2 hinges per door=2kits
each kit comes with 1 pin and 2 brass bushings
 
OP
OP
D

dfdtruckie

TYF Newbie
Joined
Nov 26, 2009
Posts
5
Reaction score
0
Location
denver
Thanks for the help everyone. Just picked up a 95' 2dr and trying to get it up to *****
 
OP
OP
D

dfdtruckie

TYF Newbie
Joined
Nov 26, 2009
Posts
5
Reaction score
0
Location
denver
Most often the problem can be cured by replacing the bronze bushings. I used an engine hoist to hold the weight of the door, while I changed mine.:)

I was looking at the door. The lower pin looks straight forward but the upper one looks like I need to compress the spring or something. Is that true?
 

95TwinTT

Full Access Member
Joined
May 23, 2009
Posts
357
Reaction score
0
Location
Minnesota
I was looking at the door. The lower pin looks straight forward but the upper one looks like I need to compress the spring or something. Is that true?

I used tyraps to hold the compressed spring, then cut the tyraps after it was back in place.

There may be a tool for dealing with that spring, I don't know.
 

rucr8z2

Full Access Member
Joined
Nov 11, 2009
Posts
100
Reaction score
3
Location
Saluda,Va.
Napa has the door check spring tool as well. but they might have to order it for the next day. like $15
 

TIM Z

DMAX Power
Joined
Oct 20, 2009
Posts
346
Reaction score
1
Location
Navarre Ohio
I just replaced my Door bushings/pins this weekened.

used a floor jack and a block of wood to help hold the door up.

Long screw driver and long 3/8 extension helped to pound out and reinstall the pins.

I borrowed a spring tool to compress the spring for reinstall.

Not too bad a job.

Door doesnt sag now, but i think my latch / striker is wore ouit from all the door shutting with worn bushings over the years.
 

Forum statistics

Threads
132,732
Posts
1,873,331
Members
97,563
Latest member
bmead21
Top