- Joined
- Jan 3, 2011
- Posts
- 50,348
- Reaction score
- 17,134
How do I connect this amp?
- Thread starter JesusArTorres
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
JesusArTorres
Full Access Member
The speaker wires don't have any label or white lines. They are identical. Do I just chance it and switch them if it didn't work the first time?
Fuse still looks good.
Fuse still looks good.
lol
LOL. I saw the bar too, but they dont always break the bar when the pop.
As for the speaker wires, just hook them up however. Since they arent marked your just guessing. Once its all hooked up and working again, watch the sub when it hits and see if the cone is pushing out or pulling in when it hits. If it pushes out then your good, if it is pushing in then flip the speaker wires. It will technically work either way.
As for the speaker wires, just hook them up however. Since they arent marked your just guessing. Once its all hooked up and working again, watch the sub when it hits and see if the cone is pushing out or pulling in when it hits. If it pushes out then your good, if it is pushing in then flip the speaker wires. It will technically work either way.
OP
OP
JesusArTorres
Full Access Member
I connected everything and it didn't work. I reversed the speaker wires and nothing. Went to a shop and the guy said it was the battery wire. $30.
Thanks for all of the info!
Thanks for all of the info!
Wow, 30$ for a single power cable. Yikes.
