WILLFG
Member
Alright so when I bought my truck it had the 3/5.5 drop on it from Tony.
The previous owner took out the stock bump stops but never put in new ones. It may not even need them but it looked like there has been contact in some places so I figured I would install them.
The truck was lowered and I did not jack it up to install these. (would have been easier if I did)
The reason for this post is to show where the pre-existing holes are at on the axle for these to be installed.
When I went to do the instal I could not find any pics. So here you go!
The previous owner took out the stock bump stops but never put in new ones. It may not even need them but it looked like there has been contact in some places so I figured I would install them.
The truck was lowered and I did not jack it up to install these. (would have been easier if I did)
The reason for this post is to show where the pre-existing holes are at on the axle for these to be installed.
When I went to do the instal I could not find any pics. So here you go!
