bboggs
TYF Newbie
- Joined
- Jul 12, 2023
- Posts
- 18
- Reaction score
- 9
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yes all the bulbs are good but the previous owner installed a stereo system and ran wires through the door trim maybe it's a groundMaybe a ground? I know I had an issue similar on an old expedition and it was a ground issue. Also, check to make sure the dome light bulb is good. I don't think the two are related other than grounding.
Thank you for the info I have pulled the motor out of the power mirrors and the wires look fine and tested my voltage meter there was no voltage..pulled the dome light cover off the roof and check for voltage and nothing with or without the override button press there is continuity between the map lights though when I hit the on and off switchDome override button next to the headlight switch? Interior lights won't work if that override is in use. Some folks leave that override button on to overcome a faulty door/dome light switch.
Also, there is a small triangular access molding at the front corner of the window opening inner side of each front door. Pop that off and that will give you access to the power mirror plug/connector. See if each is plugged in. Someone may have replaced the mirrors in the past and never plugged them in.
Also, the power mirror control switch may be culprit too. The truck may have had it's windows opened during the rain at some point and the switch shorted/corroded. Can easily remove that switch panel on the door and jump the wiring to see if in fact the switch is culprit.
Welcome to discovering someone else's journey with your newly acquired ride! And welcome to TYF from NY!
Pull the door panel off and check for voltage at the power windows and they all are fine except for the power mirror moduleYes all the bulbs are good but the previous owner installed a stereo system and ran wires through the door trim maybe it's a ground
Thank you for the info I have pulled the motor out of the power mirrors and the wires look fine and tested my voltage meter there was no voltage..pulled the dome light cover off the roof and check for voltage and nothing with or without the override button press there is continuity between the map lights though when I hit the on and off switch
Funny thing is the power mirrors were working yesterdayPull the door panel off and check for voltage at the power windows and they all are fine except for the power mirror module
Maybe the dimmer switch is the culpritFunny thing is the power mirrors were working yesterday