LEDSs headlights package

[AngelXL]

Thanks

 

[chicagofan00]

Looks good. Will be curious to hear how they hold up and if any issues arise.

 

[AngelXL]

Heads up for those that order Fog LED lights.
A lot of companies try to sell you the 5202/H16 for 2016 Yukons.
I don't know if every model is different or suburban is different but the H16 will not fit on mines.
Check out your fog lights before you place an order.
There is a fog light with 2 slots this you clip on type and a fog light with 3 slots this one you do a 1/4 turn to take off or on.

 

[motorswin]

were there any issues with fitment? did you have to alter the light like with HIDs for the dust cover?

 

[AngelXL]

Nope! Fit perfectly on both. Highs and Lows.

 

[Weber Dude]

How's the light output? Better than stock?

 

[WillCO]

That heat sink clearly extends out past where the dust cap would go. How did you handle that? Did you drill a hole in the dust cap or just leave it off?

Also, how did you handle the passenger side, where the air filter box rests right up against the dust cap? It seems like there would not be room for that heat sink and the filter box both.

 

[AngelXL]

How's the light output? Better than stock?

There is some pictures on the first page. Way way better!

 

[AngelXL]

That heat sink clearly extends out past where the dust cap would go. How did you handle that? Did you drill a hole in the dust cap or just leave it off?

Also, how did you handle the passenger side, where the air filter box rests right up against the dust cap? It seems like there would not be room for that heat sink and the filter box both.

Did you get a chance to view the whole thread? Some pictures and explanation of the mod.
The ones on the bottom are the wrong ones. Fogs LED are for different model gmc.

 

[debo4x4]

Did you get a chance to view the whole thread? Some pictures and explanation of the mod.
The ones on the bottom are the wrong ones. Fogs LED are for different model gmc.

My 15 Tahoe uses the PSX26 for the fog light so you might check that out. I did LED's in HI/LOW/FOG and used the fanless design so all components fit in the housing and I was able to close the dust covers.