MSD Parts. Did I get it right?

[2wdr]

box 6425
wires 32169
harness 8877
retainers 8843
coil 8231
cap/rotor 8017
plugs xp605
Total with tax $523.99 with a mix of Ebay and Amazon.

I am still looking at a rear end swap.....soon. That winnne is killing me.

 

[devious1]

i just read this thread last night. thought you might be interested before making your purchase. http://www.tahoeyukonforum.com/forum/showthread.php?t=14228

 

[2wdr]

i just read this thread last night. thought you might be interested before making your purchase. http://www.tahoeyukonforum.com/forum/showthread.php?t=14228

Thanks,
But... I would have a problem with only 3 or 4 comments on MSD being a bad product. One of the most common problems is owners not spreading the wires out proper. JMO.

 

[SunlitComet]

numbers are correct but if you want they make a vortec dizzy as well. 5592

 

[jerryjoe28]

I run the same set up ( with the dizzy) no problems here!

 

[Lotshp]

I been running MSD for years "NO PROBLEMS HERE" good choice. Just wondered why the 6AL and not the 6A since the ECU will have control over the rev limit?

 

[2wdr]

I been running MSD for years "NO PROBLEMS HERE" good choice. Just wondered why the 6AL and not the 6A since the ECU will have control over the rev limit?

I think it is a back up in case of an odd tuned chip.

To late to change to the dizzy, but I got my box off ebay new for $180. Maybe next month.

 

[Lotshp]

Good price on the box! Yeah I ran the 6al in a carb setup, but since my truck runs a ECU with custom chip "limiter set" I opted for the 6a same box w/o rev chips, saved a few bucks.At least now you will have a hot ignition for 8500rpm shifts LOL. So what's up with you rear diff, time to blow sound?

 

[SunlitComet]

I think it is a back up in case of an odd tuned chip.

To late to change to the dizzy, but I got my box off ebay new for $180. Maybe next month.

That is exactly why you should get the 6al. It has been used on my truck a few times because something is goofed in my 411 pcm programming when wot in first gear to second.

 

[tahoecowboy]

I have a similar setup, what did you guys do for the wire between the coil and cap? I have been looking everywhere for one and even asked summit what they recommend and they had nothing.