So I just installed a 2/3 drop kit on my 05 Suburban. Belltech drop spindles in the front and 3" coils/shock relocators in the back.
When I brought it down from the jack stands, the rear was waaaaay low, but when I started up the truck the Autoride/self leveling pump thing turned on and stayed on for much longer than usual and raised the truck back to stock height.
I've read about people bending the rods for the rear shock sensors, but no one ever says or shows how much they need to be bent. Can anyone point me in the right direction here? Instructions on the best method to bend them? How much do I bend them?
When I brought it down from the jack stands, the rear was waaaaay low, but when I started up the truck the Autoride/self leveling pump thing turned on and stayed on for much longer than usual and raised the truck back to stock height.
I've read about people bending the rods for the rear shock sensors, but no one ever says or shows how much they need to be bent. Can anyone point me in the right direction here? Instructions on the best method to bend them? How much do I bend them?
