need a picture of exhaust for drive shaft clearance on a 6in.

[darin95yuk]

ok fellas i need a picture of the way the exhaut is ran on a truck with a 6in. its right in the way of my drivshaft... ive seen some pics of guys running deep loop for clearance... gay! i have a few ideas but want to see what is workin for all of you guys....

 

[bowtiefreak]

if you wheel the truck go above the shaft. I don't wheel mine much and have the pipe routed under...but that section is also now removable so I can swap just that section at any point

 

[darin95yuk]

thanks!

 

[clean454]

i had mine routed over the top and it was pretty cheap todo most exhaust shops will kno what todo..

 

[96ProCompTahoe]

Over the top

 

[darin95yuk]

thats what i want to do but i like to wheel mine and i was kinda worried about when the driverside flexes up if the drive shaft will hit on the way up? it is no rock crawler by no means but if i need it to go where i want with fo wrenches in my gears! thanks guys!

 

[bowtiefreak]

with IFS the differential and teh shaft never move (other than rotate) That's why there is most likely no slip yoke on teh front of yours. So even if the shaft was .25" from the pipe they should never really touch (I would obviously have more clearance than that).

 

[96ProCompTahoe]

if your getting that front diff to go up and down you sir have more to worry about than just an exhaust pipe. haha

but really you'll be fine and have nothing to worry about.

 

[steamroller]

I had mine over the top until I switched to longtubes.

 

[darin95yuk]

oh wtf was i thinkin ifs not solid axle what a douche!!!!!