New fuel pump install...searched but didn't see anything...

[Physh1]

My fuel pump died today. I bought a new one w/ sender & will be dropping the tank tomorrow to install.

I know I need to un-bolt the straps & lower the tank BUT...

Are there any clips etc holding lines in place? Anything to unbolt to safely drop tank to the ground?

Do I need any special tool for the securing ring or fuel lines?

Any input or link to a thread I didn't see would be appreciated.

Cameron

 

[gdddup]

fuel line disconnect tool would be needed

 

[Physh1]

Found a nice 15 minute video on YouTube for a pump change...easier than I thought...

Cameron

 

[txsmainevent]

Found a nice 15 minute video on YouTube for a pump change...easier than I thought...

Cameron

Post the link for everybody else bro ....you know for us lazy people....

 

[redemn93]

http://tahoeyukonforum.com/forum/showthread.php?t=20916

 

[Physh1]

Youtube video...

http://www.youtube.com/watch?v=SQRDfTgq8l0

 

[alacran]

u can disconnect the fuel lines by hand on the pump i done it. now putting them back on top of the tank (not the pump) is a *****. but it should take about 1-2hrs. make sure you clean off all around the pump b4 removing it. u dont want that dirt going in the tank.

 

[Physh1]

Took 4 hours but I got it done...pretty simple actually.

Cameron

 

[Rivieraracing]

Bump for me!