Passenger side steering rack bushing? replacing

[mikez71]

I have a pretty noticeable clunk when making certain tight turns (faster U-turns etc)
I have found play at the passenger side steering rack bushing.. Can make it clunk by hand.
Purchased a GM replacement bushing,
Country of Origin = USA!?

it's a split rubber piece that looks like it was made in India..

How do I install it?

My guess..
Remove passenger tie rod from knuckle.
Undo accordion boot. Possibly need to remove tie rod end?
Unbolt passenger side bracket and slip it off?

Hoping it's easy if anyone has some tips...

 

[kbuskill]

I replaced mine with a poly bushing. It was a fight getting the poly bushing back onto the rack, hopefully the rubber is a little more forgiving.

You just unbolt the 2 bolts that hold the bracket and bushing in place and slide it towards wheel. You will have to slide the accordian boot over but you don't have to remove it completely, unless you want to.
It has been a few years since I did it.

I also installed a bracket into the bushings on the opposite end that are supposed to stiffen everything up.




They come as a kit on Amazon if you are interested.

Fits GMC Sierra Yukon Cadillac Escalade 2007-14 Chevrolet Silverado Tahoe Steering Rack Bushing Set Polyurethane 19330568 https://a.co/d/fcNsolv

 

[mikez71]

Would you look at that!? Thanks kbuskill!

Love this forum I tell ya!

 

[89Suburban]

Good stuff!! Mine needs this bad as well.

 

[Charlie207]

I replaced mine with a poly bushing. It was a fight getting the poly bushing back onto the rack, hopefully the rubber is a little more forgiving.

You just unbolt the 2 bolts that hold the bracket and bushing in place and slide it towards wheel. You will have to slide the accordian boot over but you don't have to remove it completely, unless you want to.
It has been a few years since I did it.

I also installed a bracket into the bushings on the opposite end that are supposed to stiffen everything up.

View attachment 439147
View attachment 439148

They come as a kit on Amazon if you are interested.

Fits GMC Sierra Yukon Cadillac Escalade 2007-14 Chevrolet Silverado Tahoe Steering Rack Bushing Set Polyurethane 19330568 https://a.co/d/fcNsolv

The Junglewebsite has those same pics, and it looks like it fits, but thebjne review with photos said the poly bushing was too thick to fit into the collar.

What technique did you use to drive the bushing home?

 

[kbuskill]

The Junglewebsite has those same pics, and it looks like it fits, but thebjne review with photos said the poly bushing was too thick to fit into the collar.

What technique did you use to drive the bushing home?

Those are indeed the same pics as on the site. I forgot to get pics because as mentioned it was a struggle to get it on without removing the rack.

I lubed it and used a ratchet strap to help coerce it back onto the rack. Definitely a tight fit, but that is what you want, right?

To get it inside the bracket you have to kind of fold one end inside, toward the open center, and overlap the other end to reduce the overall diameter, slide it inside the bracket then uncoil it, if that makes sense.

On a side note a few years later I replaced the whole rack, due to it leaking inside the accordian boots, and the bushing and bracket were much easier to install with it off the truck. Not sure if it was due to the angle or just overall accessibility or the fact that it had previously been installed and was "worn in" a bit or what but no real trouble changing it over to the new rack.