Post:All lowered tahoes 4dr and 2dr

[foreverfalcon40]

Good news to hear, but that doesn't apply to every vehicle on the road. Never cut springs that is on a strut. Post pics and spread the good news! Keep on Modding!

Doesn't it feel good to save money and apply towards something else? I love the feeling of doing a lot more and spending a lot less with great success! What is next?




Cut springs on a strut? my springs are between lower a ARM and frame pocket? Or are you referring to a 4wd perhaps?

You are able to get away safely with cutting springs in your situation and similar set-ups. If you do it on a vehicle equipped with struts EX: Honda Civc it is unsafe risk of Spring sliding out of perch.

 

[slowbuilt_iv]

Ok, ya I didn't figure that should've been on me lol I've done mild lowering on spring trucks for years, until I go lower then I do it all the right way bc too much can break lol

Shackles tomorrow tho! I'll have it leveled out finally, more of a 2/3 drop. Is like to run the stock Chevy 5spoke aluminum 20" after this drop and convert to 6 lug

 

[slowbuilt_iv]

(2/3)

 

[Fishintahoe]

lets see some more of these!!!

 

[992dr]

Heres my pig

 

[AtomicHoe094]

i like you!

 

[992dr]

 

[Fishintahoe]

Clean hog u got there. what are your plans for wheels and tires

 

[992dr]

Clean hog u got there. what are your plans for wheels and tires

This for me? If so, I have found a set of 20x9 moto metals w/275/45s for very short money. They're on a dropped 454SS right now.
Hoping this deal works out, if not I'm looking at C4 Vette wheels.

 

[red02chevy]

I am going to be pulling my traction bars, clearanced hangers and flip kit off my Tahoe and will be putting it all up for sale. I was thinking of selling it all as a package deal.

The flip kit is a new belltech with the big 5/8" ubolts, traction bars will include the billet press in bushing for the leafs and the hangers are factory hangers that I clearanced for the traction bar lower bolt. All hardware will be included for a "bolt on" install.

If someone is interested, PM me. You can see the parts in a few pictures I posted eariler in the thread.