I have a '96 Yuon SLE. I am in the process of replaceing the fuel feed line. MY issue is the rear strap on the fuel tank. I began to loosen the bolt, and able to back it out about a half an inch. Then it began to spin freely as if I needed to hold a nut. There is no nut to hold. I then tried to tighten it back up and it spins freely that direction as well. Am I missing somthing here? I was able to remove the strap towards the front of the tank with no problems, and it sems that bolt is threaded into the crossmember. I assume the rear strap is bolted in the same way, especially because of the limited access to the topside of the crossmember. Does anyone have any suggestions?