Right front wheel protrudes further than left?

[vcode]

Just curious, can you take a measurement from the frame to the seam weld (or something easy to measure) under the rockers to see if that is the same side to side?

 

[BADRIDES]

For like…the 5th time: the RF tire scrubs the fender, the LF does not.

Raise it up some and get smaller wheels and tires.

 

[KidWgn]

Raise it up some and get smaller wheels and tires.

They're OEM 22's.

 

[soulsea]

Posts edited.

Everyone calm down and be courteous to each other.

 

[mikez71]

body mounts shifted?
1/8" to one side would be 1/4" difference...

 

[mikez71]

oops

 

[Foggy]

I would just put it on an alignment rack and take measurements
1/4" is really not that bad as long as tire wear etc is good.
It could just be that your aftermarket wheels are a bit off or the
difference in tire sizes from OE are giving you the "scrub" concerning you
Or that when brakes or wheel bearings were done in the past that
the hubs/wheels/ etc were not all cleaned the way they are supposed to be

 

[89Suburban]

I would pull the front wheels, throw a few a few lugs on to hold the rotors snug and take some frame to back of rotor measurements to compare.

 

[KidWgn]

I would just put it on an alignment rack and take measurements
1/4" is really not that bad as long as tire wear etc is good.
It could just be that your aftermarket wheels are a bit off or the
difference in tire sizes from OE are giving you the "scrub" concerning you
Or that when brakes or wheel bearings were done in the past that
the hubs/wheels/ etc were not all cleaned the way they are supposed to be

This is the 4th set of wheels that's been on the truck. 3 OEM sets, 1 aftermarket.

 

[KidWgn]

Just curious, can you take a measurement from the frame to the seam weld (or something easy to measure) under the rockers to see if that is the same side to side?

I'll be on an alignment rack Tuesday, so I'll measure everything then!