Rocket Man's 02 Denali Build Thread AKA "THE BEAST"

[MadDogDelpho]

Make a YouTube acct. That's what I did.

Ditto

 

[08grey]

I wanna hear it.

Sent from my SM-G950U using Tapatalk

 

[Rocket Man]

Here's a short clip of a warm startup and a little punch of the throttle. Hold onto your hats fellas it's gonna get loud in the hood. Shoulda seen the look on the neighbors faces sitting on their front porch across the street.

 

[bottomline2000]

Here's a short clip of a warm startup and a little punch of the throttle. Hold onto your hats fellas it's gonna get loud in the hood. Shoulda seen the look on the neighbors faces sitting on their front porch across the street.

Death to all those wearing headphones....yup..louder than straight pipe..[emoji573]

Sent from my SAMSUNG-SM-T377A using Tapatalk

 

[Tonyrodz]

Sounds good! Is that with the new muffler?

 

[Rocket Man]

Sounds good! Is that with the new muffler?

Did you read the title of the Movie Tony?

 

[95escahoe]

Here's a short clip of a warm startup and a little punch of the throttle. Hold onto your hats fellas it's gonna get loud in the hood. Shoulda seen the look on the neighbors faces sitting on their front porch across the street.

Sounds great, quick question when you installed those Dorman manifold clamps did you use any thread locker like the instructions say or you just tightened them down?


Sent from my iPhone using Tapatalk

 

[Fosscore]

Holy crap you scared the cat that I don't even have. That is seriously loud! Can't wait to hear that cam too.

 

[Rocket Man]

Sounds great, quick question when you installed those Dorman manifold clamps did you use any thread locker like the instructions say or you just tightened them down?


Sent from my iPhone using Tapatalk

There were instructions? Guess that answers your question! I just tightened the hell out of the ones that go to the block and then torqued the ones that clamp the header down to the header gasket's specs.

 

[95escahoe]

There were instructions? Guess that answers your question! I just tightened the hell out of the ones that go to the block and then torqued the ones that clamp the header down to the header gasket's specs.

Lol ya there were some in the box


Sent from my iPhone using Tapatalk