Slurpglass
Member
Figured I’d share this gem. Also notice the hardwired ****** radar. 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Scan gauge II installed above Rear-View Mirror
- Thread starter Slurpglass
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I'm kind of partial to the blend mount myself
OP
OP
Slurpglass
Member
I had the blend mount for the radar on my previous vehicle (Subaru BRZ). In the Tahoe I feel like it hangs too low and is too visible to prying eyes. I like the visor clip mount because it keeps the radar out of sight, out of mind (although you do lose full use of the visor). I am using the scan gauge blend mount in this installation.
Sent from my iPhone using Tapatalk
Is your visor still functioning?Figured I’d share this gem. Also notice the hardwired ****** radar.
Sent from my iPhone using Tapatalk
OP
OP
Slurpglass
Member
It is if you want it to, but the radar would be pointing up, which is useless. I’m tall (6’2”) so I rarely need the visor (I just use sunglasses). I’ll try to post a few more pics later today of the radar hard wiring route.
ya I got tired of getting dvd systems stolen so I got a viper alarm with smart start, glass sensor, tilt sensor and gps. most alarms do not come with a glass sensor so thieves just break a back window crawl in take what they want and crawl back out never triggering the alarm. I also tinted all the back windows 5% and a light tint on the front so if your just passing by you cant even really see inside much. then I added a scanning 6 led light in the console (that lights up when the alarm is activated) so if there dumb enough to ignore that then there going to meet my katana.
OP
OP
Slurpglass
Member
ya I got tired of getting dvd systems stolen so I got a viper alarm with smart start, glass sensor, tilt sensor and gps. most alarms do not come with a glass sensor so thieves just break a back window crawl in take what they want and crawl back out never triggering the alarm. I also tinted all the back windows 5% and a light tint on the front so if your just passing by you cant even really see inside much. then I added a scanning 6 led light in the console (that lights up when the alarm is activated) so if there dumb enough to ignore that then there going to meet my katana.
Haha! Katana protection! I like it. Yeah, I do plan on tinting the windows the same, which will be happening sooner rather than later. The factory tint isn’t sufficient enough for the Texas heat. Though I still need to fix the driver window motor before that can happen. I did just got done wrapping the entire vehicle, so I’m trying to hold off on doing more to it for a little bit.
See it here: Dark Grey Matte wrapped 2007 LTZ Tahoe
https://r.tapatalk.com/shareLink?sh...e-wrapped-2007-LTZ-Tahoe.105490/&share_type=t
Sent from my iPhone using Tapatalk
Tonyrodz
Resident Resident
What's that scan gauge about? Got a link?Figured I’d share this gem. Also notice the hardwired ****** radar.
Sent from my iPhone using Tapatalk
OP
OP
Slurpglass
Member
It digitalizes the gauges, reads codes, and allows you to clear them as well. Check their website for more info.
https://www.scangauge.com/products/scangauge-ii/
Sent from my iPhone using Tapatalk
W8TVI
Full Access Member
Figured I’d share this gem. Also notice the hardwired ****** radar.
Sent from my iPhone using Tapatalk
Hey! That looks like the kind of MPG I get with my 2000 Yukon XL!
Similar threads
