Still looking to lower my Denali

[white15]

So I purchased the NorCal kit and installed it.... It rode really rough and was lower than I wanted. I'm looking just to bring down the rear of the truck about an 1"

The front of my truck from the ground to fender is 35" and the rear is 38" I still want a bit of a rake, but just not SOOOO drastic. Is there anything out there that will bring it down minimally and still ride like factory?

I hear of this Heater hose mod for the NorCal kit to get it lower than what the kit is designed for, I wonder if I did that on the Factory springs if it would give me the look im trying to get?

Thanks for any input guys..... GM should have just made is bodystyle with a normal rake (like the last generation)

 

[NORCAL SS]

ok what year was the denali? Now on the rear the kit you used the 1 inch spacer correct? are you just trying to get the back to sit at 37 inches?

 

[white15]

The Denali is a 2016 (I think early build though, because most of the new ones 16-17 are sitting higher in the front than mine) Yes I did use the spacer.... the back at 36.75-37" would be perfect for me

 

[NORCAL SS]

no problem. is yours a denali xl??

You can always swap out the rear spacer with a taller one which is a very simple mod.

this would lift it up 1 inch more and more travel for axle which will help on ride.
http://www.ebay.com/itm/Rear-Leveli...ash=item58d46fe830:g:AlcAAOSwa-dWma0g&vxp=mtr

 

[white15]

That could work.... is there anyway using the stock spring? Maybe getting a thinner isolator or something if they are that thick?

FYI Attached is the kit I have.

 

[NORCAL SS]

im trying to figure out why rode harsh but if you want only 1 inch of drop either the spacers or you can try the heater hose mod on stock springs and shorten the autoride rod

 

[KBones]

That box looks like its says its for 00-06 trucks...

 

[NORCAL SS]

00 to 17 it's all the same for springs

 

[KBones]

Ok

 

[white15]

00 to 17 it's all the same for springs

Thanks for all the help! I read somewhere you said the last generation has thinner shock issolators.... is that true? Will the fit on the 16 stock springs?