Sway Bar Bushings

[rmaker]

I trying to source the rear sway bar bushings for a 2011 Suburban 1500LT.

The fronts were 36mm, I measured the rear bar and it was 29.6mm??? I guess 30mm? gonna measure again but it's raining now.

Has anyone replaced these and has the part number?

Many sites do not specify the diameter - frustrating.

 

[OR VietVet]

I see 28.6mm and 29mm referenced at RA

 

[rmaker]

I went back out there and did some more measuring and came in around 28 - I grabbed some from the zone that physically measure 28.4mm - I think I m good. Gonna go put them in and see what happens.

 

[iamdub]

I went back out there and did some more measuring and came in around 28 - I grabbed some from the zone that physically measure 28.4mm - I think I m good. Gonna go put them in and see what happens.

If those don't fit, try Moog K6408.

 

[OR VietVet]

For all that served or are currently in the service or Reserves, AZ gives a 10% discount.

 

[rmaker]

They fit.
One went on like butter and one was tighter/harder to spread over the bar, I had to stretch it a bit with a needle nose first.

Thanks for the lookup.