tahoe projector retrofit.

[a4edwin]

I want to do the projector retrofit on my 03 tahoe. I want to know what part numbers or model I would need to make this happen. I did a search with no avail. Only thing I found was the one steve meade did on his truck but he doesn't mention what parts he used only where he got it from

 

[NathanJax]

http://www.tahoeyukonforum.com/threads/quad-retrofit-completed.63776/

http://www.tahoeyukonforum.com/threads/what-is-the-procces-to-switch-to-hid-head-lights.65865/

http://www.tahoeyukonforum.com/thre...sx-hid-projectors-into-depo-headlights.56686/

http://www.tahoeyukonforum.com/threads/hey-dudes-i-need-to-replace-my-projector-headlights.56497/

 

[a4edwin]

Thanks Nathan I read thru those but it's not what I'm looking for I want to retrofit into the crystal clear headlights for the tahoe. The height on the yukon and tahoe headlights are different.

 

[NathanJax]

I would imagine the projector parts would still be the same.

 

[Pachanga02]

Wow he made that look easy. If it were only that fast and easy.

 

[YukonXL04]

Those are mini h1 projectors. Variety of sources for them. Mainly theretrofitsource.com

Or the generic version from amazon or ebay.

 

[blurred]

I have recently finished mine up and I ended up using the TSX projectors from theretrofitsource.com along with some shrouds that I picked up off ebay.

I used the $75 pair of headlights/bumper lights from ebay/Amazon and cut the back off the low beam housing so that I could fit/bolt the projectors in place and cut out a flat metal bracket that was JBWelded to the back of the housing. I bolted the projector to this bracket and then sealed the whole thing up.

I had to do some trimming to the shroud (top and bottom) and very slight trimming to the projector housing to get it to fit inside the housing, but I think it turned out well. Cannot post any photos at the moment but they are in the build thread in the Under Construction section of the forum.