tore apart the ole Govbomb 10bolt today

[96ProCompTahoe]

blow it to shit and post up some pictures! haha can you swap a 2wd 14 bolt into your hoe like the 4x4 swap? should hold the power a hell of a lot better.

what cover did you pick up? i have the mag-hytec extra quart cover on mine and love it. has a built in O-ring so no RTV and no leaks

 

[AtomicHoe094]

id love to replace it now and i might end up replacing it now anyways. the bolt that i was talking about before is 53bucks!!! wtf!

haha blowing the diff sounds fun and could be trouble lol
ibought a cheap summit one has a drain plug which is always a positive. must be a big asss Oring lol

http://www.summitracing.com/parts/SME-8510300/

 

[SunlitComet]

blow it to shit and post up some pictures! haha can you swap a 2wd 14 bolt into your hoe like the 4x4 swap? should hold the power a hell of a lot better.

what cover did you pick up? i have the mag-hytec extra quart cover on mine and love it. has a built in O-ring so no RTV and no leaks

here here

 

[retorq]

What happens if you o attempt to blow the rear and you lock it up, that's gonna lock up the drive shaft and tranny output shaft ... could be a hell of a lot more then fixing the rear end.

can you swap a 2wd 14 bolt into your hoe like the 4x4 swap?

The 454SS rear is a 2wd 14 bolt 5x5 lug pattern axle ... not sure of the width though.

 

[AtomicHoe094]

pass over 600 bucks for this eaton i want, then ill put it in.

---------- Post added at 10:49 AM ---------- Previous post was at 09:27 AM ----------



53bucks for this damn bolt...

This is what broke in my brothers 03 silverado and then that blew up his rearend since the pin and shit came out..

 

[96ProCompTahoe]

very big O-ring!

sounds like a junkyard run to pull that bolt out of another 10 bolt in my opinion

 

[AtomicHoe094]

im sure all of them would be like this huh? idk going to play it by ear and see what i can find. havent checked Egay yet

 

[AtomicHoe094]

heres a bolt i found off summit for 6bucks..
http://www.summitracing.com/parts/RAT-5811/Application/?prefilter=0
same shit right?

 

[retorq]

As far as I know the pins are all the same, the cross shafts can be different based on gear selection.

 

[AtomicHoe094]

well id be a lot happier if i killed the diff with a 6dollar bolt then a 53dollar one. lol Im gunna have to order that one today then.