What did you do to your NBS GMT800 Tahoe/Yukon Today?

[03catburban]

I wonder if it's the solder joints starting to crack and will eventually need to be reflowed.

Sshhh itll hear you.lol And I dont care to deal with that right now because I'llreplace all the stepper motors and go ahead and convert to led while I'm there

 

[Tonyrodz]

Sshhh itll hear you.lol And I dont care to deal with that right now because I'llreplace all the stepper motors and go ahead and convert to led while I'm there

LOL! The guy who swapped frames, and said it was easy? Gonna put in a trans gauge?

 

[CJ Rodarme]

Those kryptonite parts are so nice! I've been putting off a full front rebuild with all their parts because it ain't cheap lol.

For sure, I probably won’t end up doing the other one until the OEM bearing goes bad because of that haha

 

[Dantheman1540]

For sure, I probably won’t end up doing the other one until the OEM bearing goes bad because of that haha

Can't blame you there, my whole front end is getting pretty wore out but the only thing that got replaced was the tierods because they were totally shot lol.

 

[Tonyrodz]

Can't blame you there, my whole front end is getting pretty wore out but the only thing that got replaced was the tierods because they were totally shot lol.

I'm about to do mine.

 

[Dantheman1540]

I'm about to do mine.

I feel they are definitely the weakest part on the GMT800 front ends. Even lowered street Tahoe wears them out lol.

 

[Tonyrodz]

I feel they are definitely the weakest part on the GMT800 front ends. Even lowered street Tahoe wears them out lol.

Hopefully my inners are good--since I don't have any to replace them.

 

[03catburban]

LOL! The guy who swapped frames, and said it was easy? Gonna put in a trans gauge?

Never said it was hard just dont feel like ripping into another cluster lol
Its one of them jobs I dont like

And as for trans guage no because I'm putting in a manual

 

[Rocket Man]

I'm about to do mine now that I found them in the back seat.

FYP

 

[Keviebear86]

My Tahoe has been sitting for a couple weeks and I went out to start it. It cranked and barely turned over but started within 5 seconds or so. My problem is now my gauges don't work and my windows and locks don't work either. Can I simply disconnect the battery and correct this with a hard reset or is there something I need to look into with the body control module? Lights and radio did not want to shut off after this started either.