What did you do to your NBS GMT800 Tahoe/Yukon Today?

[diLucca]

Changed heater core T connectors, what a b**tch, hope they will last another 20years

 

[Sam Harris]

Replaced my intermediate steering shaft. Super easy job, except for the one nut. GM is good at that shit.. this should address my clunking noise going over bumps, and dips, etc.. clunking steering noises in general. Gotta make dinner, so test drive will have to wait. The alignment of the steering wheel looks good.. hopefully.. I held it in place with the seatbelt.



This mf’er.....





Old (left) vs new:






And had to use a trick to keep the nut on the socket. This thing was a ***** to get to:



All back together:




And the steering looks pretty dead on. Fingers crossed.. don’t want to go get an alignment..




ETA: happy to report my steering clunk is gone! And so far, steering wheel seems perfectly straight and aligned. Success! [emoji106]

 

[Fless]

@Sam Harris I'm so jelly of that little LED on your headlight switch, showing you they're on.

 

[Sam Harris]

@Sam Harris I'm so jelly of that little LED on your headlight switch, showing you they're on.

Strange that you don’t have it. Probably like the rear door courtesy lights. Went from lights, to reflectors.. save $ 0.50 GM [emoji107][emoji19] I wonder if you can replace with one that has the LED..?

 

[Fless]

Strange that you don’t have it. Probably like the rear door courtesy lights. Went from lights, to reflectors.. save $ 0.50 GM [emoji107][emoji19] I wonder if you can replace with one that has the LED..?

I've looked online from time to time, but haven't found one that shows it. Have to expand my Upull prowess and hit the LKQ yards; I didn't know we had any but they're not far from the other Upulls.

 

[Tonyrodz]

@Sam Harris I'm so jelly of that little LED on your headlight switch, showing you they're on.

My 03 also has it. Should be pnp for you.

 

[Tonyrodz]

Changed the ac evaporator today, found a hack on YouTube. Now just need to charge it up.

 

[Tonyrodz]

Also did an oil change. It's the 2nd since the new motor. There were some metal slivers on the drain plug--not too happy about that.
I do mine every 2500 miles. I was actually 600 miles early. Oil was black.
Close up of the slivers.

 

[Rocket Man]

Replaced my intermediate steering shaft. Super easy job, except for the one nut. GM is good at that shit.. this should address my clunking noise going over bumps, and dips, etc.. clunking steering noises in general. Gotta make dinner, so test drive will have to wait. The alignment of the steering wheel looks good.. hopefully.. I held it in place with the seatbelt.



This mf’er.....





Old (left) vs new:






And had to use a trick to keep the nut on the socket. This thing was a ***** to get to:



All back together:




And the steering looks pretty dead on. Fingers crossed.. don’t want to go get an alignment..

Nice work Sam. That couldn’t have been easy on the back.

 

[Rocket Man]

Also did an oil change. It's the 2nd since the new motor. There were some metal slivers on the drain plug--not too happy about that. View attachment 279348 View attachment 279349
I do mine every 2500 miles. I was actually 600 miles early. Oil was black.
Close up of the slivers. View attachment 279350

Did you collect a sample to send to Blackstone or did you forget like I always do?