What did you do to your NNBS GMT900 Tahoe/Yukon Today?

[89Suburban]

been considering some ramps what ramps are these?

Got'em at Pep Boys.

https://www.pepboys.com/flotool-rhinoramp-12-000-lb-ramps-2-pack/product/9867916

 

[Sam Harris]

Got'em at Pep Boys.

https://www.pepboys.com/flotool-rhinoramp-12-000-lb-ramps-2-pack/product/9867916

Same ramps but I bought mine at Auto Zone. Never, ever buy any tools, or parts there, but they had the best price on the ramps.

 

[bigrhino]

Not needed you can just wiggle it off. Leave the nut on the shaft so you don't break your face.

Thanks.

 

[Tonyrodz]

Got'em at Pep Boys.

https://www.pepboys.com/flotool-rhinoramp-12-000-lb-ramps-2-pack/product/9867916

$44.98 each??

 

[wjburken]

$44.98 each??

Per pair.

 

[Danny3737]

Don’t forget to use some dielectric grease inside the spark plug boot so they slide on easily. It also makes it easier to remove the spark plug wires if you need to.

I’m a twig...so no problem there. I’ve got some long needle noses that should work. Those pliers you mentioned look good. I’ll first give mine a try. Thanks for the info!

 

[Tonyrodz]

Per pair.

Better.

 

[Rocket Man]

Even for the left rear plug? It seems blocked by the AC thingy from that direction and it points towards the firewall.

I cut a bit off the AC heat shield and filed the edges smooth so there’s better access but that’s on my 02. Iirc you can also just bend that shield.

 

[NOSOK]

Same ramps but I bought mine at Auto Zone. Never, ever buy any tools, or parts there, but they had the best price on the ramps.

You can find good deals on occasion. I just picked these up from advance auto the other day. 15 bucks for a 3/8 socket set from a reputable brand is not a bad deal.

https://slickdeals.net/f/14290523-1...tore-pickup?src=SiteSearchV2_SearchBarV2Algo1



For ramps I'm just using some DIY ones I made from either a 12' or 10' 2x12

 

[08z71bgm]

Did you have to use a steering wheel pulley?

Nope. Rocked it with the nut still on it while pulling it. Popped out and stopped at the nut. Seriously start to finish was about 30 mins. I spent more time looking for tools.